Dissertation > Excellent graduate degree dissertation topics show

A New Method on Rotor Position Detection and Parameter Identification for the Pms Traction Machine

Author: WuJinHua
Tutor: FanQiFu;GuoGuiShi
School: Shanghai Jiaotong University
Course: Control Engineering
Keywords: PMSM initial rotor position detection elevator parameter identification
CLC: TM341
Type: Master's thesis
Year: 2006
Downloads: 352
Quote: 1
Read: Download Dissertation


The lower-speed permanent magnet synchronous traction machine of the lift is made up of permanent magnet synchronous motor (PMSM), brake, traction pulley and absolute position encoder. The exact information of the rotor position of the PMSM is a pre-request for the driving control system. According to the presence or not of the absolute position encoder, the driving control system can be divided into two methods: one is the sensor method and another is the sensor-less method. At present, the lift driving control system generally adopts the first method, the initial rotor position is detected on turning-free (no load on the traction pulley), and the rotor position is recorded by an absolute position encoder.Whereas this research adopts the sensor-less method, the initial rotor position is detected while the rotor is at still. Considering the small saliency caused by the saturation of the stator iron, the proposed algorithm calculates the standstill rotor position and the direction of magnetization by injecting high frequency current to the stator of the machine. Meanwhile, the theory on tracking and checking the rotor position by an incremental encoder is discussed. Because there is no need to remove the traction ropes or put the

Related Dissertations

  1. Study on Drive and Control System of Five-Phase PMSM Based on FPGA,TM341
  2. Initial Rotor Position Estimation for PMSM,TM341
  3. Natural Characteristics and Dynamic Response of Mechanic Vibration System for Tractive Elevator,TU857
  4. Dynamic Test and Modal Analysis of Prestressed Reinforced Concrete Truss Beam,TU378.6
  5. Analysis of Elevator Traffic Flow Based on Five Tipical Periods,TU857
  6. A New Elevator Control System Based on CANopen High-Level Protocol,TU857
  7. VVVF Technology and Speed Control Using on Hydraulic Elevator,TU857
  8. Structural Damage Detection Based on Strain Test,TU312.3
  9. Circuit design based on super- capacitor the elevator energy saving device,TU857
  10. Design and Implementation of the elevator control system based on dual ATmega128,TU857
  11. The Research on Seismic Responses of Elevator Style Garage,TU311.3
  12. Key Technologies Research on Exchanged Header Corn Harvester,S225.51
  13. Study on Straightness of Elevator Rails Measurement Method and Experimentation,TU857
  14. Research on Remote Monitoring System of Elevator without Interface Signal,TU857
  15. Designing Carframe of Elevator Based on CAD/CAE and DOE,TU857
  16. BA System Applied on Elevators Monitoring,TU857
  17. Research and Design of Intelligent Elevator Group Control System,TU857
  18. Plastic-Damage Models and User-Defined Material Subroutine in ABAQUS Software of Concrete,TU528
  19. Study on Damping Property of High-rise Frame-supported Shear Wall Structure in View of Shaking Table Test,TU973.16
  20. Research on How the Disturbance of Gas Effect on Dynamic Characteristic of High-speed Elevator,TU857
  21. Design on the Algorithm of Elevator Group Control Based on Fuzzy Control,TU857

CLC: > Industrial Technology > Electrotechnical > Motor > AC motor > Synchronous motor
© 2012 www.DissertationTopic.Net  Mobile