Dissertation > Excellent graduate degree dissertation topics show

The Research of Fabrication Procedures on Oxide-Confined Vertical-Cavity Surface-Emitting Lasers

Author: LiZuoHua
Tutor: ZhongJingChang；ZhaoYingJie
School: Changchun University of Science and Technology
Course: Condensed Matter Physics
Keywords: Vertical-cavity surface-emitting laser epitaxy technology distributed Bragg refector oxide-confined structure
CLC: TN248
Type: Master's thesis
Year: 2004
Downloads: 152
Quote: 0
Read: Download Dissertation

Abstract


Vertical-cavity surface-emitting lasers(VCSEL’s) have distinct advantages over conventional edge emitting lasers, such as small divergence angle, single longitudinal mode operation and very low threshold current. They are especially suitable for making two-dimensional(2-D) arrays as well as VCSEL’s based integrate devices. VCSEL’s are attractive light source for various applications including optical message processing, optical interconnection and optical calculation.For the AlGaAs/GaAs VCSEL fabrication, oxide-confined structure provid electrical and optical confinement. AlGaAs/GaAs VCSEL fabricated by selective oxidation and selective etching. The lowest threshold current 1.8mA is achieved with continuous-wave at room temperature, the maximum output power is 7.96mW.For the resesrch work on the fabrication procedures, we discusses selective oxidation and selective wet etching. We found that the oxidation rate of AlxGa1-xAs layer is related to the Al concentration ,the thickness of AlxGa1-xAs layer ,the reaction temperature and the carrier gas flow. At last, we make sure the suitable condition of oxidation.

Related Dissertations

  1. Design, Processing and Characteristics Analysis of 850nm Vertical-Cavity Surface-Emitting Lasers,TN248
  2. Enterprise Techniacal Analysis and Its Applied Research,F273.1
  3. Research on Temprature Controling Technology of Laser Diode with Thermoelectric Cooler,TN248.4
  4. Erbium-doped fiber amplifier pump laser drive source research applications,TN248
  5. Studies on Terahertz Laser Optically Pumped by a TEA CO2 Laser and Its Application,TN248
  6. Research on Electro-optically Q-switched Laser with a High Repetition Rate,TN248
  7. Analysis of the Thermal Lens Effect on Yb: YAG Thin-Disk Laser Crystal,TN248
  8. New wavelength tunable laser research,TN248
  9. All Fiberized Linearly Polarized Pulsed Yb Fiber Laser with High Repetition Rate,TN248
  10. REC -based technology, the new DFB semiconductor lasers,TN248.4
  11. Brillouin erbium-doped single-mode fiber laser and its application,TN248
  12. Based on domestic devices for high power fiber lasers,TN248.1
  13. CW HF / DF chemical laser spectral distribution measurement of time and space and application analysis,TN248.5
  14. Small aperture glass-ceramics based on helium-neon laser fundamental transverse mode selected experimental study,TN248
  15. Based on differential equations laser resonator mode Fast Algorithm and Its Application,TN248
  16. Passively mode-locked fiber laser and its dispersion management,TN248.1
  17. Research of Key Technologies of Stabizing LD in Gas Detection System,TN248
  18. Study on Dual-wavelength Narrow line-width Fiber Ring Laser and Its Application,TN248
  19. Semiconductor laser power and control technology research,TN248.4
  20. Intracavity frequency doubling Raman lasers and coherent anti-Stokes collinear phase matching theory,TN248
  21. Research on 1.53μm Eye-Safe Laser Optical Parametric Oscillator,TN248

CLC: > Industrial Technology > Radio electronics, telecommunications technology > Photonics technology,laser technology > Laser technology, the maser > Laser
© 2012 www.DissertationTopic.Net  Mobile