Dissertation > Excellent graduate degree dissertation topics show
The design of receiver for ultra wideband automotive anti-collision radar
Author: LiZhaoBo
Tutor: YangXiaoLin
School: University of Electronic Science and Technology
Course: Radio Physics
Keywords: equivalent time sampling UWB sampling gate DDS radar data processing
CLC: TN957.5
Type: Master's thesis
Year: 2012
Downloads: 23
Quote: 0
Read: Download Dissertation
Abstract
|
Due to the increase of the amount of vehicles, the rate of car accident is rising. It is very significant to research the anti-collision radar. According to the12th five-year plan of China, government has taken the automobile intelligent electronic into the plans and the research on the anti-crashing radar system is going far, and created an excellent platform for research.To achieve high sensitivity, high sampling rate and high input bandwidth ADCs(Analog-to-Digital Converter) are strongly required, while most of them are designed in the foreign companies, which cause high cost, still, it has a problem of high data transfer rate. This design focus on the problem of low sampling rate and low input bandwidth for low cost ADC, and a UWB sampling gate base on equivalent time sampling is designed, which has an equivalent theory bandwidth of6.35GHz and equivalent sampling rate of20Gsa/s.This paper is formulated around the deceleration principle of the UWB(Ultra wide band) sampling circuit, also, two methods of designing the circuit are presented. According to the simulation of the circuit with ADS(Agilent Advanced Design System), the sampling bandwidth and the rate voltage conversion efficiency is calculated. The circuit based on SPD(Sampling Phase Detector) is tested, and the feasibility of the circuit is improved. Step frequency signal is essential for equivalent-time sampling. The step frequency signal is formulated by circuit based on DDS(Direct Digital Synthesizer). To minimize the jitter, a differential filter is designed. The step frequency signal forming circuit was proved of good performance. Finally, we process and display the radar data. After filtering, B-scan imagining, median filtering, direct wave filtering, we can locate the obstacle precisely.
|
Related Dissertations
- Development of LXI Arbitrary Waveform Generator,TM935
- DBF baseband data Simulator Design and Development,TN955
- Excitation System Design and Research of High-frequency Fatigue Machine,TH871.3
- DSP-based multifunction millimeter-wave radar data processing extension design and implementation,TN958
- DBF microwave system design and implementation phase locked source,TN911.8
- Research polyphase coded signal,TN957.51
- Digital FM exciter audio signal processing method,TN912.3
- LXI bus based dual-channel arbitrary waveform generator design,TP274
- Design and Implementation of the Arbitrary Waveform Generator Hardware System Based on FPGA,TN741
- Research of Fast Wideband Frequency Synthesizers,TN74
- Design of Multi-channel Function Generator with External Synchronous Single-cycle Trigger,TM935
- Software Design and Implementation of FPGA - based HF Digital IF system,TN925
- Development of Test Platform for the Helicopter Electrical System Based on PXI Bus,V216.8
- The Application Study of the GPR in Highway Engineering Detection,TN959.71
- Research on Ultrasonic Flow Measurement System Based on FPGA,TH814.92
- Design and Implementation of Radar Signal Simulator Based on DDS,TN955
- PXI 200MSPS arbitrary waveform generator module hardware design,TM935
- Based on SOPC technology programmable waveform generator design,TM935
- Dedicated radar signal generator based on SOPC technology research,TN952
- Short-range surveillance radar data processing algorithms and software design,TN959.11
- The Research of Component Composition Mechanism Based on DDS Architecture,TP311.52
CLC: > Industrial Technology > Radio electronics, telecommunications technology > Radar > Radar equipment,radar > Radar receiving equipment
© 2012 www.DissertationTopic.Net Mobile
|