Dissertation > Excellent graduate degree dissertation topics show

The Design of Multi-channel Sequential Control Signal Generator

Author: WuShangShang
Tutor: ZhangQingXiang
School: Harbin Institute of Technology
Course: Information and Communication Engineering
Keywords: FPGA Verilog HDL synchronous trigger multi-channel
CLC: TM935
Type: Master's thesis
Year: 2012
Downloads: 23
Quote: 0
Read: Download Dissertation

Abstract


With the rapid development of modern science and technology, data acquisitionand processing technology is applied more and more widely. But because of therequirements of scientific research and and the actual project, single channel dataacquisition has been unable to meet the design requirements, especially now many highresolution methods are based on the data of the multiple channels, and data phasecoherence requirement of the multiple channels is very high, so multi-channel analogsignal must ba sampled synchronously in the project implementation. The design, whichis involved in this article, uses an ADC in each channel, the subsequent processorcontrols the operation of data transfer of multiple channels, the purpose of this design isto complete the multi-channel synchronous trigger control.In this article virtex-5FPGA of the Xilinx corporation is the core of the design, anda multi-channel timing control signal generator is designed, which controls thesynchronous trigger control of the multi-channel sampling. The hardware designscheme of signal generator is gived. Combining with the performance requirements ofthe device, the key chips are selected. In this paper the specific schematic design ofsignal generator is gived, it includes the input clock level conversion module, RS-232serial communication level conversion module, Virtex-5FPGA chip with its peripheralcircuit module, the single channel differential signal to the multi-channel circuit moduleand a power supply circuit module. After the completion of the schematic design, all ofsymbol package were produced based on the chip data sheets. If the path of symbolpackage was setted, netlist was imported into the circuit board, and layout and wiringwork was completed.This paper also gived the software design of the virtex-5FPGA, the design toolwas the Xilinx’s ISE13.3software. First, the principle of RS-232serial communicationwas analyzed, the specific design of the UART was gived, each of the modules of thedesign was described in detail, and then a cache RAM module of the control word wascompleted, and finally the timing control signal generating modules wans finished, theModelSim was used to complete the function and time sequence simulation of eachmodule. The software program was downloaded to FPGA chip, and it was debuggedand analyzed. The results were compared with the performance of the design, whichshowed that the accuracy of the system design. The done work was summarized, andput forward some further improvements advices.

Related Dissertations

  1. Research on Electromagnetic Acoustic Transducer Detection System Based on FPGA,TH878.2
  2. Study on Drive and Control System of Five-Phase PMSM Based on FPGA,TM341
  3. Development of LXI Arbitrary Waveform Generator,TM935
  4. Development of the Multichannel Body Information Detector Based on Meridians,TH776
  5. Design of Digital Predistorter for RF Power Amplifier Based on FPGA,TN722.75
  6. Study on Channel Allocation of Multi-Channel MAC Protocol in Ad-Hoc Network,TN929.5
  7. Synchronization and Channel Estimation Algorithm in Bursted OFDM System and Its Implementation on FPGA,TN919.3
  8. Performance Analysis of Anti-Multipath Capability in DSSS System and Study on the Compensation Methods,TN914.42
  9. Optimizing and Realising Research on Vedio Compression in TV Guidance System,TN919.81
  10. Research and Hardware Simulation of Multiuser Spread Spectrum Code Acquisition Based on FPGA,TN914.42
  11. Research on Basic Algorithms of Digital Image Processing and Implementation with FPGA,TP391.41
  12. Research of High Speed Image Pre-processing System Based on FPGA,TP391.41
  13. The Design of the Dual-Camera High-Speed Synchronous Capturing System Based on Gigabit Ethernet,TP274.2
  14. Design of High-Speed Digital Image Acquisition and Interface Based on FPGA,TP274.2
  15. Development of Inductance Sensor Data Acquisition System Based on FPGA,TP274.2
  16. Development of Serial Bus Analyzer Based on Nios,TP274
  17. Development of PMC High-speed Data Transmission Board Design Based on FPGA-RocketIO_X,TP274.2
  18. Development of Pxibus High Performance Digital I/O Module,TP274
  19. Development of LXI Counter,TP274
  20. A High-Speed and Real-Time Data Acquisition System Based on FPGA,TP274.2
  21. Design of GPS Information Receiving System Based on Nios Ⅱ,TN967.1

CLC: > Industrial Technology > Electrotechnical > Electrical measurement techniques and instruments > Frequency, waveform parameter measurement and instrumentation
© 2012 www.DissertationTopic.Net  Mobile