Dissertation > Excellent graduate degree dissertation topics show

Design and Implementation of Digital Signal Detection System for RFOG

Author: YaoLingZhi
Tutor: MaHuiLian
School: Zhejiang University
Course: Microelectronics and Solid State Electronics
Keywords: Resonator fiber optic gyro digital PI controller CORDIC algorithm FPGA
CLC: V241.5
Type: Master's thesis
Year: 2012
Downloads: 60
Quote: 0
Read: Download Dissertation

Abstract


Fiber optic gyro is an inertial angular velocity sensor with high precision based on the Sagnac effect. It plays an important role in a variety of navigation and guidance systems. Compared with the well-developed interference fiber optic gyro (IFOG), resonator fiber optic gyro (RFOG) has the advantage of system miniaturization. The digital signal processor has better stability, quicker processing speed, smaller size and stronger anti-interference ability when compared to the analog circuit. Using FPGA as the core hardware, the digital signal processor for the RFOG based on the sinusoidal phase modulating technology is designed and implemented. The lock-in accuracy of the resonance frequency servo loop has been improved. A miniaturized digital RFOG system is carried out. The main research works of this article are as follows.A digital proportional-integral (PI) controller is incorporated into the resonance frequency servo loop. A simulation model is setup to optimize the loop parameters considering of the loop noise reduction and dynamic performance of the RFOG system. The digital PI controller implemented on FPGA significantly reduces the loop delay, which greatly improves the noise suppression in the low frequency range. Through a reset mechanism, the long-term lock-in performance of the PI controller is improved. The lock-in frequency stability of the resonance servo loop is about 0.044/h (1σ) with the integration time of 0.16 seconds (equivalent bandwidth of 1 Hz). It is close to the theoretical sensitivity of the RFOG.A digital signal processor is designed and implemented on FPGA for an RFOG based on the sinusoidal phase modulation technology. Both the modulation signal generators and the synchronous demodulation are all digitalized based on the CORDIC algorithm. To overcome the backscattering induced noise, two sinusoidal voltage waveforms with different modulation frequencies are applied to the clockwise (CW) and counterclockwise (CCW) lightwaves of the resonator, respectively. Their amplitudes are also optimized to reduce the backscattering induced noise. The digital lock-in amplifier implemented on FPGA can detect a small signal of only to 10nV, corresponding to a rotation of 10-4°/s for the RFOG used in our experiment. To enhance the usability and flexibility of the RFOG system in debugging and data processing, a serial communication and control system between the computer and FPGA are designed and implemented.An RFOG based on the aforementioned digital signal processor implemented on FPGA is setup. Rotation rates have been measured from 0.05°/s to 5°/s. A bias stability of about 68.31°/h in an hour is successfully demonstrated in the digital RFOG with the integration time of 0.16 seconds.

Related Dissertations

  1. Research on Electromagnetic Acoustic Transducer Detection System Based on FPGA,TH878.2
  2. Study on Drive and Control System of Five-Phase PMSM Based on FPGA,TM341
  3. Development of LXI Arbitrary Waveform Generator,TM935
  4. Design of Digital Predistorter for RF Power Amplifier Based on FPGA,TN722.75
  5. Synchronization and Channel Estimation Algorithm in Bursted OFDM System and Its Implementation on FPGA,TN919.3
  6. Performance Analysis of Anti-Multipath Capability in DSSS System and Study on the Compensation Methods,TN914.42
  7. Optimizing and Realising Research on Vedio Compression in TV Guidance System,TN919.81
  8. Research and Hardware Simulation of Multiuser Spread Spectrum Code Acquisition Based on FPGA,TN914.42
  9. Research on Basic Algorithms of Digital Image Processing and Implementation with FPGA,TP391.41
  10. Research of High Speed Image Pre-processing System Based on FPGA,TP391.41
  11. Design of High-Speed Digital Image Acquisition and Interface Based on FPGA,TP274.2
  12. Development of Inductance Sensor Data Acquisition System Based on FPGA,TP274.2
  13. Development of Serial Bus Analyzer Based on Nios,TP274
  14. Development of PMC High-speed Data Transmission Board Design Based on FPGA-RocketIO_X,TP274.2
  15. Development of Pxibus High Performance Digital I/O Module,TP274
  16. Development of LXI Counter,TP274
  17. A High-Speed and Real-Time Data Acquisition System Based on FPGA,TP274.2
  18. Design of GPS Information Receiving System Based on Nios Ⅱ,TN967.1
  19. Temperature and pressure explosives temperature field memory test technology,TQ560.7
  20. Erbium-doped fiber amplifier pump laser drive source research applications,TN248
  21. Remote FPGA system design and implementation of security upgrades,TP309

CLC: > Aviation, aerospace > Aviation > Aircraft instrumentation,avionics, flight control and navigation > Aircraft instrumentation,aerospace equipment > Gyro instrument
© 2012 www.DissertationTopic.Net  Mobile