Dissertation > Excellent graduate degree dissertation topics show

Research on Multi-step Constant-current /Constant-voltage Charging Device Based on DSP Control

Author: KongLiLi
Tutor: ChaoZeYun
School: Huazhong University of Science and Technology
Course: Power Electronics and Power Chuan Chuan
Keywords: battery charging constant-current/constant-voltage phase-shifted ZVS DSP
CLC: TM910.6
Type: Master's thesis
Year: 2011
Downloads: 45
Quote: 0
Read: Download Dissertation

Abstract


The Battery charging technique is a subject which has been concerned widely in the battery application fields, it is the key factor which affects the battery life. But because of the complex charging process, and the simple charging methods in practical application greatly decrease battery life, a reasonable slection of charging methods is very important; and at some particular situation, various voltage-levels battery are needed, for charging conveniently and reasonably, the charging devices must be rationality and generality. This paper described a charging device which is suitable for the battery of voltage-level under 24V, the charging method is two-stage charging strategy.At first, this paper described some widely used charging methods, and determined constant-current and constant-voltage charing as this charing device’s charing methods. Then according to the accepted charing current, this device selected a two-stage charing, that’re constant-current/constant-current and constant-voltage/constant-voltage strategy, it is suitable for the charing requirements of ni-cd alkaline battery and lead-acid battery.This charging device is powered by three-phase AC, in order to decrease the current harmonic caused by rectifier, lower conducted interference to AC power grid, this part uses 12 pulse rectifier with autotransformer. And in order to reduce the switching loss, the phase-shifted ZVS full bridge cell was used. IGBT was selected as the switch that was drivered by 2SD106AI-17 module. The charging control system was based on DSP chip (TMS320LF240). Using this topology, higher frequency could be gained、switching loss was much redused and control system was telligent and so on.The control principles of charging device were time、voltage and mixed principle. This paper also presented a design method of the PI algorithm of integral separation and variable parameter. At last, the experimental results from the prototype indicate that the software works properly, and constant-current and constant-voltage charging are realized.

Related Dissertations

  1. Design of Electronicalcontrol System for Electronic Jacquard Knitting Machine,TS183
  2. Research on the Integrated Grating Subdividing Digital Display Device Based on DSP,TH822
  3. Study on Two Dimensional of Auto-Collimator Based on DSP,TH741.14
  4. Study on the Control System for Automatic Aiming of HWIL Pitching Mechanism,TJ303
  5. Research on Synchronous Motor Excitation Control System,TM341
  6. The AES Algorithm and Its Implementation in DSP,TN918.1
  7. The Design of a DSP-Based Robot Speech Command Recgnition System,TN912.34
  8. Research on Signal Receiving System of Phase Laser Range Finder,TN249
  9. Study on Implementation Technology of Channel Estimation in OFDM System Based on DSP,TN919.3
  10. Optimizing and Realising Research on Vedio Compression in TV Guidance System,TN919.81
  11. Voice Signal De-noise Base on Wavelet and Arithmetic Implement with DSP,TN912.3
  12. Research on Image Compression and Implementation Using TMS320C6713 Based on SPIHT Algorithm,TP391.41
  13. A Study on the Technology of the Infrared Image Matching,TP391.41
  14. Development of 3-Dimensional Scanning Probe Data Acquisition System Based on DSP,TP274.2
  15. Development of Vxibus Common Interface Module Based on DSP,TP274
  16. Research of Acoustic Signal Acquisition System Based on DSP,TP274.2
  17. Research of DSP-based Real-time Demodulation Method of One-frequency Laser Interferometer,TN911.3
  18. Laser alignment system posture measuring device developed,TN24
  19. ATV vehicle weapon control system,TP273
  20. Design of VoIP Gateway Based on DSP,TN916.2
  21. A Novel Controller Design for Active Power Filter with Low Switching Loss,TN713.8

CLC: > Industrial Technology > Electrotechnical > Independent power supply technology (direct power) > General issues > Charging method,charging equipment
© 2012 www.DissertationTopic.Net  Mobile