Dissertation > Excellent graduate degree dissertation topics show

Design of High Current Synchronous Rectified Buck DC/DC Converter

Author: LiuWenZuo
Tutor: XuanZongQiang
School: Xi'an University of Electronic Science and Technology
Course: Measuring Technology and Instruments
Keywords: DC/DC Converter High Current Slope Compensation PLL
CLC: TM46
Type: Master's thesis
Year: 2011
Downloads: 140
Quote: 0
Read: Download Dissertation

Abstract


Based on the project“Design technique research of mixed-signal IC for single chip”, the paper studies the principle and circuit design of high current synchronous rectified step down DC/DC converter.The paper exhaustively analyses the fundamental principles and the key technique of Buck DC/DC converter. The establishment of Small-signal control models for current model stability and compensation networks is deeply studied. According to the above, a high current synchronous Buck DC/DC converter XD7618 is designed and implemented. Synchronous rectification technique is applied in the chip that advances the efficiency evidently. A novel structure of current mode compensation is presented to eliminate the slope compensation effect on the peak current of the inductor, and a optimize circuit of slope compensation, which can not only insure the loop stability but also effectively reduce the over compensation’s influence on the load capability, is designed. XD7618 applies phase-lock loop to realize the function of outer synchronization so that decrease the mixing noise when multi-DC/DC are using, the frequency capture range is from 300 KHz to 2 MHz. TypeⅡbuilt-in frequency compensation method is adopted to simplify the peripheral circuit. Furthermore, output detection circuit, over temperature protection, under voltage lock out and over current protection are also integrated in XD7618.After the principle analyzing and circuit designing, based on 0.35um 20V BCD processing, the sub module and the whole chip are simulated by using the EDA tools of Cadence. The results show that the output current is up to 7A and the efficiency is high to 93.8%, the chip gets an excellent performance of load capability.

Related Dissertations

  1. Well Detection Pump Steady-Speed Driving System of Brushless DC Motor,TM33
  2. Grid-Side Converter Control and Wind Turbine Emulator in Direct Drive Wind Power System,TM46
  3. The Research and Design in Low-power、 Low-stray Frequency Synthesizer of WCDMA Terminal Tester,TN74
  4. The wide input high gain Isolated DC-DC converter,TM46
  5. MATLAB-based all-digital BPSK receiver carrier synchronization technology research,TN919.3
  6. FPGA-based digital readout device research and design,TP212.14
  7. X-band low phase noise PDRO Design and Implementation,TN752
  8. A low jitter CMOS PLL design,TN911.8
  9. Super capacitor energy storage system DC conversion technology research,TM53
  10. DSC-based Power System Harmonic Measurement Method,TM935.2
  11. Millimeter-wave radar frequency step frequency synthesizer design,TN958
  12. Shortwave radio frequency source synchronous design and research,TN74
  13. DBF microwave system design and implementation phase locked source,TN911.8
  14. DSP-based research IGBT induction heating power supply,TM924.5
  15. Phase control of the piezoelectric transformer DC / DC converter based on,TM46
  16. Supercapacitor-based energy technology research and implementation of the elevator,TM92
  17. Fractional-N frequency synthesizer Modeling and Design,TN74
  18. New embedded memory module study,TP333
  19. The Design and Implement of Controlling Crystal Oscillator Based on TDC-GP1,TN752
  20. Study of Digital Controlled Bi-directional DC/DC Converter,TM46
  21. The Research of Isolated DC/DC Converter with Low Voltage/High Current Output Based on Secondary-side Control,TM46

CLC: > Industrial Technology > Electrotechnical > Transformers, converters and reactors > Converter
© 2012 www.DissertationTopic.Net  Mobile