Dissertation > Excellent graduate degree dissertation topics show

Design and Implementation of Program-controlled Excitation Power Source Based on DDS

Author: WenJin
Tutor: LouPing；LiuZuo
School: Wuhan University of Technology
Course: Control Engineering
Keywords: Fuel Cell DDS Program-controlled the excitation power source
CLC: TM911.4
Type: Master's thesis
Year: 2011
Downloads: 47
Quote: 0
Read: Download Dissertation

Abstract


Performance evaluation of the fuel cell plays a key role in ensuring fuel cell works efficiently and security, while excitation source is an important part of the performance testing system. In the research of resistance test system of the fuel cell and the Current Skin Effect on proton exchange membrane fuel cell, excitation source should provide sinusoidal wave, square-wave and triangle wave signals, and the excitation current should be large enough. Thus, a design of a excitation power source which can output various wave signals is getting more and more importance. The paper gives a design of excitation power source system which based on DDS technology to meet the demand for the fuel cell performance evaluation. The paper discusses the problem as below:This paper introduces the form and the principle of the excitation power source system which based on DDS technology, by analysing the requirements for the Fuel Cell Impedance Monitoring and The Research of Current Skin Effect on Proton Exchange Membrane Fuel Cell, further improves can be done to consummate the structure of the excitation power source system.Based on the theory of DDS, this paper designs the digital part in DDS structure and its interface with the MCU by using Quartus II development platform. And then designs the filter and programmable-gain amplifiers circuits, the signals pass through these circuits will become well and the waveform amplitude can be controlled. At last, the paper designs the Power Amplifier circuit to improve the load capacity of the system.In order to improve the operability and security, the paper designs the operate panel of the excitation power source system with Lab Windows/CVI. The operator can use the panel to control the excitation power source and get the status of the excitation power source.During the testing phase, the performance of the excitation power source fully achieves the design objective, so the excitation power source can fully satisfy the requirements for Fuel Cell Impedance Monitoring and The Research of Current Skin Effect on Proton Exchange Membrane Fuel Cell.

Related Dissertations

  1. Numerical Analysis of Flow Process in a Molten Carbonate Fuel Cell,TM911.4
  2. Fabrication of Membrane Electrode Assembly for PEMFC,TM911.4
  3. Development of LXI Arbitrary Waveform Generator,TM935
  4. Pt -based catalysts of direct methanol fuel cells,TM911.4
  5. Morphology Control Synthesis and Anode Electrocatalysis Performance of Pt/Pd-based Catalysts for Fuel Cell,TM911.4
  6. Study on the Synthesis of the Polypyrrole-Cobalt Oxides and Their Catalytic Behavior for the Electroreduction of H2O2,O643.32
  7. LSGM electrolyte thin films and electrochemical properties of,TM911.4
  8. Electricity Generation from Swine Wastewater in Microbial Fuel Cell, Microbial Community Analysis, and Isolation of Electricigens,X71
  9. Preparation and Properties of Platinum-based Catalysts for Potential Use in PEMFCs,TM911.4
  10. Thermal Cycle Stability of SOFC Seal Material,TM911.4
  11. Stainless steel fuel cell bipolar plate and its experimental and simulation,TM911.4
  12. Resistant chromium poisoning , high-performance solid oxide fuel cell cathode materials research,TM911.4
  13. Solid oxide fuel cell with a gas turbine Novel Hybrid System Simulation,TM911.4
  14. Based on the principle of suction air -breathing direct methanol fuel cell three-dimensional numerical simulation,TM911.4
  15. Fuel cell vehicles with high-frequency inverter system harmonic analysis and suppression,TM464
  16. New fuel cell electrolyte membrane polyether sulfone Preparation and Properties,TM911.4
  17. Air-cooled proton exchange membrane fuel cell dynamics control and performance testing of,TM911.4
  18. Microbial fuel cell system processing nitrophenol Wastewater,X703
  19. DBF microwave system design and implementation phase locked source,TN911.8
  20. Research polyphase coded signal,TN957.51
  21. Microbial fuel cell processing aniline and nitrobenzene wastewater,TM911.4

CLC: > Industrial Technology > Electrotechnical > Independent power supply technology (direct power) > Chemical power sources,batteries, fuel cells > Fuel cell
© 2012 www.DissertationTopic.Net  Mobile