|
The wipes are a hygienic cleaning supplies essential to people's daily lives. Since entering the market, with its soft, clean, health, the use of simple, easy to carry has been the favorite of consumers, the majority of young women especially popular consumer favorite. With the socio-economic development and people's living standards improve, wipes market is expected to continue over the next dozen years prosperity and rapid growth. Wipes brought a series of waste disposal problems, however, also continue to increase the burden on the environment. Therefore, an urgent need for a class do not have to be dumped or burned, and friendly to the environment can be broken up. This paper can be broken up wipes to proceed with the raw material of non-woven materials, then research into net composite process and optimize the process of spunlace reinforcement. Research carding webs and composite wood pulp paper process, explore the composition of raw materials, wood pulp content, surface density, into a network of processes, composite processes, the spunlace process of product performance; Finally, the optimized production process can be broken up sexual Wipes materials, and market a domestic wipes material can be broken up contrast. The results show that: the flat viscose fiber has a special flat cross-sectional shape, the bending stiffness of the fiber is lower than circular viscose fiber, which makes flat viscose fibers into a network and processing, with a ratio of a circular viscose The fibers better entangled performance. Good to break up the wood pulp paper flat viscose fiber composite spunlace material, wood pulp fiber content is higher, can be broken up, the better. Taking into account the requirements on the strength of the daily use of the wipes, wood pulp fiber content should be controlled within 75%. The surface density of the material can be broken up, a more appropriate range of the surface density of 40g/m2-60g/m2. Carded, airlaid material obtained may be broken up differences are small, but in order to ensure the longitudinal strength, mechanical carded more suitable, and the use of carded webs and kraft paper more preferably double-layer composite. During spunlace reinforcement, using the pre-wet pressure of 20bar, and the composite spunlaced pressure of 30bar-35bar, the transport network shutter speed of 15m/min, spunlaced height of 40 mm, and process conditions of the two spunlaced nonwoven material mechanical properties and can be broken up. Wet wipes and market a domestic wipes material can be broken up contrast, the subject material to meet national wipes standard premise, good to break up. Solve practical problems related processing, through the research, promoting the wipes can be broken up product development, promote the production, science, and the combination of research has important practical significance.
|