Dissertation > Excellent graduate degree dissertation topics show

Research on the Preparation Craft and Performance of Porous Ceramics Material

Author: ZhangJin
Tutor: HanYaZuo；SunTaiLi
School: Shenyang University of Technology
Course: Materials Science
Keywords: Porous ceramics Polymeric sponge Dipping Filter
CLC: TQ174.6
Type: Master's thesis
Year: 2009
Downloads: 291
Quote: 1
Read: Download Dissertation

Abstract


It is studied the preparation of porous ceramics in this paper.The Al2O3 powder is added to wollastonite or cordierite,and polymeric sponge is dipped into slurry,after that porous ceramics is produced by sintering.Through experiments,it is proved that the porous ceramics have sufficient porosity and strength.The experimental results show that different components correspond to different parameters.It is summarized the best agglutination craft as follows:regarding to wollastonite porous ceramic,when alumina powder（coarse size） accounts for 30%,appropriate craft is 1590℃for 60 minutes;when Al2O3 powder（500nm） accounts for 70%,appropriate craft is 1620℃for 60 minutes;For porous ceramic added cordierite powder,when Al2O3 powder（500nm） accounts for 60%, its appropriate craft 1650℃for 60 minutes;And adopting grain collocation,the best craft is 1600℃for 60 minutes.The microstructure of ceramics was observed in SEM.It was founded that the skeleton connected with each other in three-dimensional;the holes are similar to circle; diameter of porous ceramic is between 0.5～5mm,and the diameter of ceramic skeleton is between 0.15～0.8mm;the sectionis compact and even.Experiments of strength and thermal shock resistance show that,strength of porous ceremic added cordierite is much higher than which added wollastonite;the ceremic adopted grain collocation is strong.Which could be applied in filtering of melt liquid.It is analyzed effect of all the crafts on ceremic properties.Results show that bubble solution concentrations in the range of 10%to 20%between the pre-soaking time 6～10h,which could get good performance porous ceramic material.For sponge of big aperture,dipping once or txice is both well;but the small ones shoud be dipped only once.For every composition,there will be a corresponding craft.In summary,the best craft parameter has been reseached,and good porous ceremics for filtering melt liquid.are preparated.

Related Dissertations

  1. Research on Single-phase Photovoltaic Grid-connected System,TM464
  2. Research and Design of Common Weighing Device Based on STM32,TH715.1
  3. Multi-channel Data Acquisition System for 3D Induction Logging Tool,P631.83
  4. Study on High-speed Terahertz Modulation Based on Photomixers and Terahertz Filters,O441
  5. A Research of DC-DC Converter by Fuzzy Variable Structure Common Model Adaptive Control Methods,TP273
  6. Research on Defense of DDoS Attacks Against the DNS Server,TP393.08
  7. Based on Filtered Estimate 3D Registration Algorithm Research,TP391.9
  8. Research of Wireless Sensor Network Information Fusion and Target Tracking Problem,TN929.5
  9. Design and Fabrication of Micro Fabry-Perot Tunable Filter,TN713
  10. The Manufacture and Properties Studies of PTFE Architectural Membrane Structure Materials,TU599
  11. Technique of Compensation and Parameter Calibration for High-speed and High-precision Motion Control,TG659
  12. Two Classes of Filter Method for Constrained Optimization Problem and Its Application in Lot-Sizing Model,O224
  13. Pilot Study of Fertilizer Industry Wastewater Using Biological Aerated Filter,X786
  14. Research on the Biological-Conventional-Membrane Water Treatment Technology,TU991.2
  15. Researchand Design of Localization System in Wireless Sensor Networks,TN929.5
  16. On Application of GPS to Navigation and Positioning for Mini-UAV,V249.3
  17. Research on Blood Vessel Centerline Extracting in Retina,TP391.41
  18. Research on Moving Object Detection,TP391.41
  19. The Design and Implementation of a NEL-Based GTP Analysis and Monitoring System,TN929.5
  20. Research of Channel Estimation Based on Pilot for MIMO-OFDM System,TN919.3
  21. Design of Fully Integrated On-chip LC VCO,TN752

CLC: > Industrial Technology > Chemical Industry > Silicate > Ceramic Industry > Production process and equipment
© 2012 www.DissertationTopic.Net  Mobile