Dissertation > Excellent graduate degree dissertation topics show

Mix Design of Grouting Mortar and Investigation of the Influence on Preplaced-Aggregate Concrete

Author: ZhenZheng
Tutor: LuXiaoHua
School: Shantou University
Course: Structural Engineering
Keywords: Preplaced-aggregate concrete Grouting mortar Mineral admixtures Shrinkage Strength
CLC: TU528
Type: Master's thesis
Year: 2011
Downloads: 47
Quote: 0
Read: Download Dissertation

Abstract


As an alternative structural strengthening method, preplaced-aggregate concrete(PAC)strengthening method has its unique advantages in many situation ,such as water conservancy project, bridge strengthening ,especially suitable for reinforcement of columns .PAC can be the best solution for many repairs . Aggregate can be readily and tightly packed into confined areas needing repair-even those with limited access and with overhead obstructions. It’s hard to use this method because of the strength of PAC is low which is caused of the Construction technology .thus, increasing the strength of PAC is the work of this paper.In this research, the author analyzed the structure, the failure mechanism and the strength influencing factors of PAC. The important factor is grouting mortar. In order to improve the performance of the grouting mortar, a series of additive contents of the admixture tests were carried out. Finally we get a series of grouting mortar with high strength、low shrinkage、high fluidity. It prepared for the latest experiment.The results reveal the relationship between the strength of PAC and the strength of grouting mortar. The PAC with the fly ash has a lower strength than the one without. The PAC with the slag has a higher strength than the one without. The test results showed that the axial compressive strength reached higher than 37.9MPa by using the mix-design. The strength of PAC meets the request of the code, so we can use the method in actual structures.The strength of PAC is liner with the strength of grouting mortar. The results show that the strength of PAC can increase 7.5Mpa because of the different combination of the grouting mortar. An important feature observed in the PAC was its failure by cracking through the stone aggregate particles. So we can get that the bond of grouting mortar and aggregate is an important factor to the strength of PAC.

Related Dissertations

  1. Study on Springback of High-Strength Steel Stamping,TG386
  2. Experimental Study of Porous Composite Materials on the Base of Recycled Concrete Powder-Cement,TU528
  3. The Experimental Research on Regeneration Aggregate and Proportioning of Recycled Concrete Brick,TU528
  4. The Research on the Formation and Application of Carbonaceous Mesophase,TQ127.1
  5. Recycled aggregate semi- rigid concrete preparation and molding of test,TU528
  6. Study on Preparing the High Performance Fiber and Nonaporous Fiber by High Viscosity Nylon-6,TQ342
  7. The Influence of the Core Strength Training on the Balance of the Junior Wushu Athletes,G852
  8. The Research of Concrete Shrinkage and Creep Experiment,TU528
  9. Finite Element Analysis and Optimization Design of a Tractor Cab,S219.02
  10. A Biocompatibility Study of the Ultrapro Mesh,R656.2
  11. Different Bottom Structure of Dental Brackets Affect the Adhesiveness-Three Dimensional Finite-element Analysis,R783.5
  12. The Experiment of Normal Bond Properties between FRP and Concrete,TU528.572
  13. Research on Microstructures and Properties of FeMnCrNiAlBSi/Cr3C2 Coatings,TG174.44
  14. Investigation of Plasma Sprayed NiCr-Cr3C2 Coating on Mould CrZrCu Alloy Plates,TG174.442
  15. Study on Dyeing and Finishing Performance of Silk/Viscose Blended Fiber,TS102.52
  16. The spatial characteristics of scientific cooperation and Its Influencing Factors,G322.1
  17. The Effect of Different Microwave Polymerizations on Accuracy and Physical Properties of Denture Base Resin,R783.6
  18. Racing Top Analysis and Countermeasure of Shenyang Science and Technology Innovation Ability,G322.7
  19. Research on Modification of Fly Ash Fibers and Enhancement of Tensile Strength of Paper Made from Fly Ash Fibers,TS71
  20. The Preparation and Properties of Carbon Foam and Its Composite,TB332
  21. Microstructure and Properties of 9Cr-ODS RAFM Prepared by PM,TG142.1

CLC: > Industrial Technology > Building Science > Building Materials > Non-metallic materials > Concrete and concrete products
© 2012 www.DissertationTopic.Net  Mobile