Dissertation > Excellent graduate degree dissertation topics show

Prepare and Study of the Performance of Lithium-nickel-cobalt-manganese Oxides Cathode Material for Lithium-ion Batteries

Author: ZhaoJunFeng
Tutor: HuGuoRong
School: Central South University
Course: Electrochemical Engineering
Keywords: ultrafine grinding spray drying LiCo1/3Ni1/3Mn1/3O2 co-precipitation Li[Li0.2Mn0.54Ni0.13Co0.13]O2
CLC: TM912
Type: Master's thesis
Year: 2011
Downloads: 737
Quote: 2
Read: Download Dissertation

Abstract


The lithium- nickel -cobalt- manganese oxides cathode as the cathode materials for lithium ion battery offer the advantages of higher capacities of discharge and excellent cycle life and higher tap density etal.LiNi1/3Mn1/3Co1/3O2 has become attractive as an alternative cathode material for LiCoO2.The Li[Li0.2Mn0.54Ni0.13Co0.13]O2 is considered as the next promising cathode used in lithium ion battery for electric vehicles.In this paper,we have systematically studied LiNi1/3Mn1/3Co1/3O2 and Li[Li0.2Mn0.54Ni0.13Co0.13]O2 separately using ultrafine grinding - spray drying method and carbonate co-precipitation method.The precursor of LiNi1/3Co1/3Mn1/3O2 was obtained by ultrafine grinding-spray drying method with spherical Ni(OH)2, Co3O4, Mn3O4 as the raw materials.The effect of synthesizing conditions such as lithium source,calcination temperature etal on the characteristics of LiNi1/3Co1/3Mn1/3O2 have been studied.The optimal technological conditions for prepared LiNi1/3Co1/3Mn1/3O2 were the precursor mixed with excessive 5% lithium hydroxide monohydrate sintered at 500℃for 3h then sintered at 900℃for 12h after Mechanical ball mill.It showed an initial discharge capacity of 164.4mAh/g at 0.1 C rate between 2.8 and 4.3 V,and its capacity retention was 99% after 30 cycles.The discharge capacity at 2C rate was 142.3Ah/g. It showed an initial discharge capacity of 167.8mAh/g at 0.1C rate at 55℃,and its capacity retention was 98.9% after 10 cycles.The capacity at 2C rate was 150.7Ah/g.When the voltage of charge increases to 4.4V,4.5V,4.6V,the discharge capacity were respectively 168.9mAh/g,183.7mAh/g,195mAh/g at 0.1 C rate at room temperature with excellent cycle life.The precursor of Li[Li0.2Mn0.54Ni0.13Co0.13]O2 has been synthesized by a carbonate co-precipitation method. The effect of the pH value, the feeding mode etal on the characteristics of precursor and the electrochemical properties of Li[Li0.2Mn0.54Ni0.13Co0.13]O2 cathode material were separately inspected.The well-distributed spherical precursor with about 10μm can get at 50℃for 10h with the pH value was fixed to 9.0, and the stirring speed of the mixture was fixed to 600r/min in the three-phase parallel feeding mode.Li[Li0.2Mn0.54Ni0.13Co0.13]O2 cathode material prepared from the precursor showed an initial discharge capacity of 252.4 mAh/g at 0.1C rate between 2 and 4.8 V,and its capacity retention was 99% after 20 cycles. The discharge capacity at 0.2C rate, 0.5C rate,1C rate,were respectively 229.3mAh/g,199.6mAh/g, 172.8mAh/g. Li[Li0.2Mn0.54Ni0.13Co0.13]O2 showed an initial discharge capacity of 285.1mAh/g at 0.1C rate between 2 and 4.8 V at 55℃, and its capacity retention was 97% after 20 cycles,. the efficiency of the first charge and discharge was increased 69.9% to 84.3% after it was treated with HNO3 of 0.2mol/L for 2h.

Related Dissertations

  1. Recovery Whey Soy Protein by Microfiltration and Development of Whey Powder,TQ936.2
  2. Numerical Simulation of Atomization and Evaporation Processes in Multi-Spouted FGD Reactor,X701.3
  3. Studies on Synthesis, Characterization and Properties of Fe-V Co-doped TiO2 Catalyst,O614.411
  4. The Study of TWC Catalytic Removal NOx from Waste Incineration Flue Gas,O643.36
  5. Al Doped Zno Transparent and Heat Insulation Coatings,TB383.1
  6. The Research on Preparation Technology and Sintering Behavior of Rare Earth Aluminates (Dy3Al5O12、 NdAlO3、LaAl11O18),TB383.3
  7. Analysis on the Influence of Ultrafine Grinded IFR on Anti-dripping Property of Polyester Fibers,TS195.592
  8. The Improvement of Post-treatment Technology of Heparin Production Process and the Study of Low Molecular Weight Heparin Production Process,R94
  9. Microencapsulation of Glycerol Monolaurate,TS202.3
  10. Optimization of Drying Process for Marine Biocontrol Yeast Rhodosporidium Paludigenum,TS202.3
  11. Preparation of the High Voltage LiNi0.5 Mn1.5 O4 Cathode Material and in Situ Xrd Study for Its Phase Transition,TM912
  12. Infiltration of molybdenum -copper composite material prepared,TB331
  13. Studies on Scale-up Technology of Naringinase Fermentation and Its Enzyme Preparation,TQ925.9
  14. Study on Synthesis of Cationic Styrene-acrylic Emulsion and Preparation of Redispersible Emulsion Powder,TQ316.334
  15. Research on the Sweet Almond Microcapusule Technology and the Character of the Microcapusule,TS221
  16. Study and Preparation of W-Cu Composites Reinforced by Film Coated Carbon Fiber, SiC Fiber and SiC Whisker,TB333
  17. Spherical porous tungsten powder preparation technology research,TB383.3
  18. Macro-Silica Spheres: Preparation and Applications for Heavy Metal Ion Adsorption,O647.32
  19. Preparation and electrochemical properties of lithium iron phosphate cathode material,TM912
  20. LiFePO4 as Cathode Material in Li-ion Batteries,TM912

CLC: > Industrial Technology > Electrotechnical > Independent power supply technology (direct power) > Battery
© 2012 www.DissertationTopic.Net  Mobile