Dissertation > Excellent graduate degree dissertation topics show

Ultrafine ammonium dihydrogen phosphate new preparation

Author: ZhuHongYa
Tutor: PanRenMing
School: Nanjing University of Technology and Engineering
Course: Safety Technology and Engineering
Keywords: ADP preparation method freeze-drying anti-solvent
CLC: TQ442
Type: Master's thesis
Year: 2009
Downloads: 185
Quote: 2
Read: Download Dissertation

Abstract


In this paper,the feasibility and technology regularity of superfine ADP were studied by two preparation methods of freeze-drying and anti-solvent.It was found that both methods of direct freezing and spray freezing were able to get superfine ADP powders with small,uniform distribution and weak agglomeration.The particles were finer and more uniform by spray freezing while the solution segregation Phenomena existed in direct freezing.The conditions with low solution concentration,large surface area,shallow solution loading and fast frozen were in favor of getting superfine ADP of small,uniform distribution and weak agglomeration by method of direct freezing.There were three factors with solution concentration,injection pressure and spray distance which impacted on the granularity of ADP by spray freezing.The solution concentration was the greatest impact,followed by injection pressure,while spray distance was the last.The superfine ADP powders were obtained with the average particle size of 3.12μm When the solution concentration was 0.1mol/L,injection pressure was 0.6Mpa and spray distance was 5cm.The study also found that the method of anti-solvent could prepare the superfine ADP powders,and different sizes of particles could be obtained through the control of experimental conditions.There were three factors with Solvent anti-solvent temperature difference,pressure and stirring speed which impacted on the granularity of ADE The Solvent anti-solvent temperature difference was the greatest impact,followed by pressure, while stirring speed was the last.The superfine ADP powders were obtained with the average particle size of 11.74μm When Solvent anti-solvent temperature difference.was 90℃, pressure was 0.6Mpa and stirring speed was 500r/min.All powders were detected by laser particle size analyzer,SEM,XRD and DSC.The result showed that the ADP particles were 5～13μm with Spherical or irregular shape by direct freezing;3～10μm with Uniform distribution,bar or needle shape by spray freezing; 11～25μm with large particle size and wide distribution by anti-solvent.The crystallization and decomposition temperature of the ADP particles prepared by either direct freezing or spray freezing were reduced to some extent,while anti-solvent changed a little.

Related Dissertations

  1. Convergence and Stability of Numerical Solution of Stochastic Differential Equations with Piecewise Continuous Arguments,O211.63
  2. Preparation of ITO Quai-1D Nanostructures by Sol-Gel Method Combined with Porous Anodic Aluminum Oxide Template,TB383.1
  3. Study on the Synthesis Bi3.25La0.75Ti3O12（BLT） Nanotubes and Nano Wires,TB383.1
  4. Hydrothermal Synthesis of Oxide Hollow Spheres,TB383.4
  5. Research on the Structure and Characteristics of Permanent Magnetic Coupling,TH139
  6. Development of Turbine Rotor Dynamic Balance System,TH877
  7. Research on Electromagnetic Acoustic Transducer Detection System Based on FPGA,TH878.2
  8. Design and Research on Stabilization Loop of Gyro Stabilized Pod Control System,V241.5
  9. Error Analysis and Measurement Method Design for the Hemispherical Resonator Gyro,V241.5
  10. Robust Adaptive Control Algorithms Research for the System of Spacecraft Attitude Dynamics,V448.22
  11. Study on Coupled Radiation-Phase Change Heat Transfer in Semi-Transparent Materials,V259
  12. The Method for Inertial Platform Testing and Parameter Identification,V249.322
  13. Effectiveness Evaluation on the Jointed Combat of the Multiple Missiles and Research on Combinatorial Optimization Algorithm,TJ760.1
  14. Research on Data Acquisition and Processing Methods for Weapon Evaluation System,TJ06
  15. Simulation Analysis on Temperature Stress of RCC Arch Dam and Its Construction Joints Design Research,TV642.2
  16. The Study on Structural Calculation and Analysis Method of Lattice-type Crane with Variable Cross-section Boom,TH21
  17. Transient Thermal Analysis of Multi-Body System with Complicated Boundary Conditions,TK124
  18. Power System Dynamic Voltage Stability Simulation Study Based on Precise Integration Method,TM712
  19. Study of Tin Alloy Carbon Composite Used for Lithium Ion Battery,TM912.9
  20. Application of Interior-Point Theory for Reactive Power Optimization in Large Power Systems,TM714.3
  21. Multiple ANN/HMM Hybrid Used in Speech Recognition,TN912.34

CLC: > Industrial Technology > Chemical Industry > The chemical fertilizer industry > Phosphate
© 2012 www.DissertationTopic.Net  Mobile