Dissertation > Excellent graduate degree dissertation topics show

The Research on the Performance and Discharge of Diesel-DME Blends on the Diesel Engine

Author: XuZhaoLi
Tutor: DuanShuLin
School: Dalian Maritime University
Course: Marine Engineering
Keywords: Diesel Engine Diesel-DME Blends DME Combustion Simulation
CLC: TK427
Type: Master's thesis
Year: 2008
Downloads: 147
Quote: 5
Read: Download Dissertation

Abstract


This paper presents a brief introduction to the situation of domestic and international resources. After a careful analysis of the situation, we come to know the huge resource pressure, the shortage of petroleum and environmental pollution in particular. Therefore, in addition to various energy-saving measures, a new generation of energy should be found in the use of motor to utilize the existent resource more effectively, and it will be a new way to reduce the excessive dependence upon petroleum resource. Dimethyl Ether(DME), as a substitute fuel, displays huge developmental potential. And this is in accordance with our country’s condition, conductive to fully take advantage of our abundant coal resource.Currently, the application of DME in diesel engine is still in research stage, while the research on combustion performance blended with DME is instructive to development and optimization of diesel engine. The paper shows a systematic discussion about 3D math mold and calculation method of values in the process of in-cylinder work. FIRE software developed by AVL Corporation in Australia is used in this paper to conduct out the creation and web partition and generation of geometric mold, and verify the chosen calculation mold. Apart from those, simulation calculation of was engaged in the process of air fluid in engine with different DME ration, atomization and combustion; velocity distribution in-cylinder, spray development, temperature field and density filed of combustion are shown in detail.The comparison about in-cylinder pressure of diesel-DME blends, temperature field and density field of diesel-DME blends leads to tranquil combustion in diesel engine blended with different ration of DEM, which is a great help to weakening of noise and decrease of machine load. Since no C-C bond exists in DME structure with the lover boiling point, easy vaporization and high-quality of spray atomization of diesel fuel, it is conductive to obstruct the formation and soot omission. Meanwhile, DME is characterized by a higher cetane number, good ignition performance, reduced ignition delay and premixed combustion, so there was the most combustion pressure and lower temperature in cylinder to inhibit the formation of NO_x. On the other hand, due to the higher latent heat value compared with diesel fuel, the evaporation process demands a great amount of thermal energy and reduces the in-cylinder temperature, which to some degree also prohibits the NO_x formation.

Related Dissertations

  1. Study on Synthesis Intermediate of Vinyl Acetate Ethylidene Diacetate from DME and Syngas,TQ225.12
  2. High Pressure Common Rail Diesel Engine Fueled with Biodiesel test under different atmospheric pressure,TE667
  3. Applied Research of Emulsified Fuel on S195 Diesel Engine,TE626.24
  4. Simulation Study on the Spray and Combustion Characteristics of LPG-DEM Blends on the DME Engine,TK437
  5. Research on the Cast Iron Inoculation Process Optimization,TG255
  6. Modeling and Simulation of Circulating Fluidized Bed Boiler Combustion System,TK229.6
  7. The China Aviation pipe DVOR / DME navigation station signal coverage and comprehensive analysis of the flight procedures and research,V351.37
  8. Experimental Study on Performance and Emissions Characteristics of CI Engine Operated with Methanol/DME Dual-Fuel,TK428.9
  9. Carbon dioxide reforming of dimethyl ether using γ-Al 2 O 3 load Ni, La Catalysts,TQ116.2
  10. Low boiling point fuel lubricity Evaluation Method,TH117.22
  11. Research on Spray Characteristic of DME Engine Based on Image Processing,TK46
  12. Simulation Study on Spray and Combustion Process of One DME Yacht Engine,U664.1
  13. Nanjing Han capacity of 200,000 tons of dimethyl ether project financial feasibility study,F406.72
  14. The Synthesis of Dimethyl Ether from the Hydrolysis of Methyl Bromide,TQ223.24
  15. An Experimental Study on the Combustion and Exhaust Emissions of An HCCI Engine Operated with DME/Methanol Dual Fuels,TK407.9
  16. Chiropractic therapy literature and clinical suitability certificate , operating Technical Specification,R244.1
  17. Research on Monitoring System Base on DME/DVOR Navigation Equipment,TN966
  18. Research on Intelligent Control for Rail Pressure of High Pressure Common Rail Diesel Engine,TK427
  19. Design and Reseach on Electronic Control Unit for Electronic Unit Pump System of Diesel Engine,TK423
  20. Research on Development and Design of Common Rail Diesel Engine Semi-Physical Simulating Platform,TK427
  21. Research on System of Condition Monitoring and Fault Diagnosis for Diesel Engine Using DSP,TK428

CLC: > Industrial Technology > Energy and Power Engineering > Internal combustion engine > Diesel engine > Run test
© 2012 www.DissertationTopic.Net  Mobile