Dissertation > Excellent graduate degree dissertation topics show

Hardware Development of an Electronic Control System and its Experimental Study on a Compressed Natural Gas Engine

Author: LvZhenHua
Tutor: HeBangQuan
School: Tianjin University
Course: Power Machinery and Engineering
Keywords: Compressed natural gas engine electronic control unit air fuel ratio closed loop control
CLC: TK433
Type: Master's thesis
Year: 2007
Downloads: 171
Quote: 1
Read: Download Dissertation

Abstract


Air pollution, global warming and energy shortage are the problems to be solved in the development of automobiles. Natural gas, as an alternative fuel for internal combustion engine, is one effective way to decrease engine emissions, to change energy structure and abate tight energy supply. The development of electronic control technolgy has more and more effect on engine emission reduction, performance enhancement and fuel economy improvement. Therefore, much attention is paid to studying and developing engine electronic technology.Based on a XC164CS singlechip, an electronic control system including programmable peripheral interface circuit, clock circuit, reset circuit and power supply circuit was designed for a multi-point sequential injection natural gas engine. An input circuit of oxygen sensor signal, drive circuit of fuel injection and ignition were also designed. The choice of components, decoupling and filter of printed circuit board wiring and channel separation were considered to improve the reliability and anti-interference capability of the system in the hardware circuit design .Based on the control system, comparative studies were conducted on the variation of air fuel ratio under the conditions of closed loop and open loop air fuel ratio control on a compressed natural gas engine.The study shows that the electronic control system can meet the requirements of natural gas engine tests. Through air fuel ratio closed loop control, the variation of lambda is lower than that at the condition of open loop air fuel ratio control. The electronic control system provides an engine test platform at steady conditions.

Related Dissertations

  1. Realization of Fiber Optic Gyroscope Signal Processing Circuits Based on FPGA,V241.5
  2. The Design and Implementation of Control System for Wire-steel Heat Treatment Direct-fired Furnace,TP273
  3. Based on closed-loop control design electrical nerve stimulation,R742.1
  4. Hydraulic automatic transmission electronic control system research and development,U463.212
  5. Research on the Control System Structure and Heading Control Technique of "Hello Ⅰ" ROV,TP242.3
  6. Design and Implementation of the Photovoltaic Inverter System,TM464
  7. The Research of Matrix Converter Based on Fuzzy Controls,TM46
  8. The Research and Development of Flow Characteristic Test-bed about Motorcycle Electronic Controlled Injector,TK413.84
  9. Experimental Investigation and Numerical Simulation on Natural Gas Combustion and Emissions in a Passenger Car Engine Equipped with an Electronic Fuel Injection System,TK431
  10. Design of Electronic Control Unit for Electric Supercharger,TK423
  11. Study on the Fuel Film Dynamic Effects and Air Fuel Ratio Control for Gasoline under Transient Conditions,TK417
  12. Automotive Electronic Control Engine MCD related technologies,U472.9
  13. Research on Fuel Film Dynamic Characteristics of Ethanol and Gasoline Blends,TK411
  14. Research on Air-Fuel Ratio Control Method for Gasoline Engine Base on MATLAB,TK412
  15. The Study of Closed-loop Control Strategy for FAI Motorcycle,U483
  16. Automobile Engine Centralized Control System Base on CAN_bus,U464
  17. The Design and Implementation of Combustion Control System for Regenerative Walking-beam Furnace,TP273
  18. Design and Reseach on Electronic Control Unit for Electronic Unit Pump System of Diesel Engine,TK423
  19. Controller Design and Study of Electrical Power Aided Steering System Based on H_∞,U463.4
  20. Study on Electric Power Steering Control System of Vehicle,U463.4
  21. The Study of Engine Electronic Speed Control System Based on Model Identification,TK423

CLC: > Industrial Technology > Energy and Power Engineering > Internal combustion engine > Gas fueled internal combustion engines > Structure
© 2012 www.DissertationTopic.Net  Mobile