Dissertation > Excellent graduate degree dissertation topics show

ASIC Design of Micropower Low Noise LDO Regulator

Author: LiuHongYan
Tutor: LaiXinQuan
School: Xi'an University of Electronic Science and Technology
Course: Circuits and Systems
Keywords: power management LDO power consumption noise dynamic frequency compensation
CLC: TM44
Type: Master's thesis
Year: 2006
Downloads: 118
Quote: 0
Read: Download Dissertation

Abstract


With the fast growing development of low-power consumption and high-efficiency portable electronic products, the performances of power management ICs are improved higher and higher. As a kind of the power management ICs,LDO (low dropout) linear voltage regulator has become more and more important and popular nowadays.Because of the advantages of high performance-price ratio, small size, simple periphery circuit, and micropower consumption, LDO linear regulator has been widely used.Based on the project "Theoretical research and design of key techniques for CMOS LDO", a micropower low noise and ultra LDO XD1095 is designed in this paper.On the basis of analyzing systematically the general structure,operation principle and key techniques of LDO linear regulator, the fundamental structure and the sub-block circuits are designed in detail.The PMOS transistor is adopted as the pass element to make the typical dropout voltage only 60mV, the design of ultra low dropout voltage. fast turn-on and turn-off, and low quiescent current as well as others reduces the power consumption mostly; The characteristics of LDO, including the noise and PSRR(power supply rejection ratio)are analyzed, and a low-pass filter is introduced specially for the bandgap which is the primary noise contribution so the noise of bandgap and the system is reduced remarkably; The frequency and phase characteristics as well as the theory of compensation are analyzed and considered in detail.Because of the demand of LDO’s stability, dynamic frequency compensation circuit is designed instead of the output capacitor’s ESR(equivalent series resistance), so the system’s stability in the whole range of load is improved and cost is reduced evidently;The over-temperature and over-load protection circuits are introduced to shut down the chip whenever the operation temperature is too high or the load is too large to protect the chip to be damaged.When all of the operation conditions is recovered, the chip starts up automatically;ViewDraw, Hspice and other EDA software are used in circuits design and run simulation in many compounding conditions of model,temperature and power supply voltage, etc..The results of simulation meet the function and specification: Finally, some key techniques of analog layout are raised from the point of view of project, which provide references for layout design of the chip.

Related Dissertations

  1. Design of Servo Control System with Linear Motor Based on Digital Filter Technology,TM359.4
  2. Packet Loss Recovering Technology for Speech Transmission over Network,TN912.3
  3. Research and Implementation on Content-Based Clothing Image Retrieval,TP391.41
  4. Research on Servo Control System of Gyro-Stabilized Platform,TJ765
  5. Research of Acoustic Signal Acquisition System Based on DSP,TP274.2
  6. Study of Acoustical Signal Transmitter Which Based on Sigma-Delta Modulation,TN761
  7. Experience · Memory · narrative,I712.074
  8. Moving target trajectory analysis based Intelligent Traffic Monitoring System,TP277
  9. Experimental Improvement of Continuous Variable Entanglement Enhancement,O431.2
  10. Uniform Image Quality Achieved by Individual Tube Current Modulation in Coronary CT Angiography: Preliminary Study,R816.2
  11. Research of Adaptive Active Noise Control Based on Neural Network,TP183
  12. Software Approach to Implement Power Optimization in Embedded Handheld Mobile Gis Device,TP311.52
  13. The surface geometry noise removal of non- local variational model,TP391.41
  14. Research of Image Enhancing of Vein Based on Fuzzy Theory,TP391.41
  15. Anlysis and Control the Noise of Low Pressure Gear Pump,TH325
  16. Analysis and Design of Low-Noise Charge-Pump PLL,TN911.8
  17. Charge-Pump PLL Z-domain Analysis and Low Noise Design,TN911.8
  18. Research on Precoding for MIMO System,TN919.72
  19. Research on Low Power Techniques of the Instruction Fetching Unit in Embedded Processors,TP332
  20. The Design and Realization of Image Processing in Vehicle-mounted Pavement Crack Detection System,TP391.41
  21. Research on Noise Reducation and Color Interpolation Algorithms Based on Bayer Pattern Images for Digital Camera,TP391.41

CLC: > Industrial Technology > Electrotechnical > Transformers, converters and reactors > Stabilizer
© 2012 www.DissertationTopic.Net  Mobile