Dissertation > Excellent graduate degree dissertation topics show

Research and Design of DC Electricity Metering Equipment in Off-board Charger

Author: ZengYongLing
Tutor: WanXiaoFeng;ZhangChunQiang
School: Nanchang University
Course: Electrical Engineering
Keywords: off-board charger DC electricity metering equipment CS5464 chip MFCM200 reader module
CLC: U463.6
Type: Master's thesis
Year: 2011
Downloads: 65
Quote: 1
Read: Download Dissertation

Abstract


In 2006, the State Council promulgated the "decision on strengthening energy", from energy security strategy and a high degree of sustainable development, and vigorously promote energy conservation. Energy industry as one of transportation, attaches great importance to the field of energy conservation and the sustainable development of transport energy, will study the development and use of energy-saving and new energy vehicles as "energy saving" an important measure.Electric vehicles are energy-saving and new energy vehicles in today’s major development; charging system for electric vehicles to provide energy supply to run, is an important basis for supporting electric vehicle systems.In the energy conversion process necessarily involves electricity trade settlement. On-board charger for charging mode of communication, the use of smart meters for energy exchange measured in the field has a very mature technical support. Based on the above background, this article focuses on off-board charger DC charge mode, research and design of DC electricity metering equipment. Based on CS5464 chip energy metering structure and principles, the main design of the voltage sampling circuit, the current sampling circuit, oscillator circuit and other hardware, as well as the main program, calibration software design; the same time, based on MFCM200 reader module structure and principle, the main design MCU interface of the module and the antenna circuit and other hardware, as well as the main program, MFCM200 with the IC card control software design.

Related Dissertations

  1. The Inductive Load Based Vehicle Body Network Control System,U463.6
  2. The Development of Vibration Signal Analysis System for Transmission Based on LabVIEW,U463.212
  3. The Development and Research of ABS Test Bench Based on Virtual Instrument,U463.526
  4. The Research of Four-wheel Steering Based on Optimal Control and Co-simulation,U463.4
  5. Engine and control system design is based on virtual instruments and CAN bus,U463.6
  6. Co-simulink of Active Suspension Control Based on VP Technology,U463.33
  7. Static Strength and Vibrational Mode Simulation Ansys of Axle’s Shell,U463.218.5
  8. Multi-body Dynamics Simulation of Bus with Air Suspension,U463.33
  9. Research on Local Environment Mapping for Autonomous Vehicle,U463.6
  10. Research on Navigation of Intelligent Car Based on Monocular Vision Feedback,U463.6
  11. Research on Key Smoothing Technology of Class A Surfaces for Anto Body,U463.82
  12. Research fully hydraulic wet brake system features large mining trucks,U463.5
  13. Research of Car Brake Pad Internal Defects Detection System Based on DSP System,U463.5
  14. Simulation and Design of Heat Exchanger of Automobile Air-conditioning,U463.851
  15. Sustainable Product Design for Automotive Interior Trimming Parts: Investigation on Design Process & Assessment Tools,U463.839.2
  16. Chassis Electronic Control Unit and System Integration Technology Based on BUS,U463.1
  17. Vehicle Instrument Panel Head Impact Issue Solving Based on DFSS,U463.7
  18. Hydraulic automatic transmission electronic control system research and development,U463.212
  19. Heavy Vehicle Transmission Transmission Parts Performance Analysis and Research,U463.212
  20. Quality pre-planning in automotive parts proofing System,U463

CLC: > Transportation > Road transport > Automotive Engineering > Automotive structural components > Electrical equipment and accessories
© 2012 www.DissertationTopic.Net  Mobile