Dissertation > Excellent graduate degree dissertation topics show
Research on Single-Phase Boost Power Factor Correction
Author: ChangJianJun
Tutor: YanYangGuangï¼›MengXiaoLi
School: Nanjing University of Aeronautics and Astronautics
Course: Power Electronics and Power Drives
Keywords: Boost converter Power factor correction Digital Signal Processor Discontinuous inductor current mode Critical continuous inductor current mode Continuous inductor current mode Soft-switching technology
CLC: TM714
Type: Master's thesis
Year: 2005
Downloads: 1115
Quote: 15
Read: Download Dissertation
Abstract
|
Power electronic products widely used on the grid causing serious harmonic pollution . This makes the power factor correction technology to become one of the hot power electronics . Since the nineties , power factor correction technology has made considerable progress made ??many novel power factor correction theory and topology. With high-speed , low-cost digital signal processors, digital control and power factor correction techniques provide the latter with a more powerful means and methods. In this paper, Boost power factor correction circuit technologies are analyzed and studied. The first chapter is an introduction, describes the power factor correction technology and the development of digital signal processors , explains the research background and purpose. The second chapter is divided into two parts, one is the inductor current discontinuous mode power factor correction technology , analyzes its working principle, derived DCM constraint relations and inductance parameter design formulas based on MC56F8013 chips produced a prototype ; its Second, by the analog control chip to achieve the critical continuous mode power factor correction methods for the design and experimental verification . The third chapter introduces the development and generation DSP chip DSP chips used in this paper the basic properties , described in detail by this chip digital power factor correction technology and methods, and experimental verification . The fourth chapter focuses on DSP-based soft- switch with power factor correction technology , and gives experimental results and analysis . Finally, the fifth chapter is the full text summary , summed up the whole issue of research and propose further work envisaged .
|
Related Dissertations
- The Research of a Novel High Efficiency PFC Circuit Based on One Cycle Control,TM46
- The Research of Control System of Permanent Magnet Synchronous Motor Based on DSP,TM383.42
- A Novel Controller Design for Active Power Filter with Low Switching Loss,TN713.8
- Design of the Adjustable Parameter ECG Signal Generator Based on DSP and MCU,TP368.12
- AUV Integrated Navigation Algorithm Study and System Implementation,U666.1
- The R&D of Drive System and Brushless DC Motor for Industrial Fan,TM33
- Based on DSP and CPLD design and implementation of motion control card,TP273
- DM6467 DSP processor- based multi-channel H.264 video encoding software design,TN919.81
- Lights with LED drive power research and design,TM46
- Permanent magnet linear motor Magnetic Levitation System Control Strategy,TM359.4
- Research on Key Technologies of Monocular Visual Odometry Based on DSP,TP391.41
- Detection of Finger Motion Gesture and Its Study on the Control of Manipulator,R318.0
- Design of a Programmable MPPT Control Technology Based on FPGA,TP273
- Design of the Memory System for Digital Signal Processor,TP333
- Key Issues and Implementation of Multicarrier Modulation,TN919.3
- Research and design of distribution transformer monitoring terminal,TM421
- Based on single-phase bridge topology active PFC inverter heat pump thermal station power,TM46
- The Research of High Power Factor Correction and Soft Switching Inverter,TM921.51
- The Designation of Permanent Magnet Synchronous Motor AC Servo System Basing on DSP,TM921.541
- High Efficiency AC/DC Conversion Technique Based on LLC Resonant Circuit,TM461.5
- Design and Realization of Lithium-Ion Power Battery Management System,TM912
CLC: > Industrial Technology > Electrotechnical > Transmission and distribution engineering, power network and power system > Theory and Analysis > Load analysis
© 2012 www.DissertationTopic.Net Mobile
|