Dissertation > Excellent graduate degree dissertation topics show

Blended with alcohol waste boiler design

Author: SongJunZheng
Tutor: ZhangChuanJu
School: Shandong University
Course: Power Engineering
Keywords: Alcohol waste Combustion Fluidized bed Thermal equilibrium Heat exchanger
CLC: TK229
Type: Master's thesis
Year: 2005
Downloads: 83
Quote: 0
Read: Download Dissertation

Abstract


The alcohol wastewater discharged in the production of alcohol is a high concentration of organic wastewater, COD content is very high, if handled improperly impact on the environment caused by a lot of pollution. There are a variety of processing alcohol waste, but most of them are not completely solve the problem of environmental pollution, the alcohol waste analysis, boiler incineration the alcohol waste of organic pollutants completely burned . To do so, not only to achieve zero emissions of waste water and alcohol waste burned as fuel, energy savings, while the ash can be used as potash, alcohol production enterprises will have a better economic and social environmental benefits. Research and development fueled with alcohol waste boiler Unlike the boiler, starting from the characteristics of the alcohol waste, considering its viscosity, concentration of into the furnace, the heat transfer characteristics of the combustion characteristics and produce smoke. Thermodynamic calculation of boiler design, layout, obtained by the heat balance analysis and reasonable heating surface of the boiler thermal efficiency of 77.2%. Boiler thermodynamic calculation special composition of the flue gas heat exchanger between the heating surface is different from coal-fired boilers, there are differences in the various coefficient selection with conventional boilers. Conventional boiler combustion devices are analyzed and discussed the proposed the alcohol waste incineration introduced into the fluidized bed from top to bottom spray fluidized bed black liquor. Black liquor gun each layout surrounded by water wall in the furnace wall, the alcohol waste is injected into the furnace by the gun down, rapid warm-up encounter high temperature flue gas and fluidized bed material in the course of the whereabouts of the black liquor evaporation, combustion and burning embers. At the bottom of the furnace, the line arrangement of many small hood to form a fluidized bed. When the boiler operation, high-speed primary air is ejected from the hood of the orifice, the bed material in the blowing on a fluidized bed, a fluidized state, to make the furnace into a material within the loop. Fluidized bed material is a relatively large regenerator, it has played a key role in alcohol wastewater into the furnace heating. Combustion mode with extended the alcohol waste residence time in the furnace, and accelerated heat, evaporation and combustion speed is conducive to the alcohol waste burning ember, to improve the thermal efficiency of the boiler. The discussions also focused on the boiler design the layout and the role of secondary air. In the next three on the gun burner arranged secondary air, the ratio of 1:1:1, and the secondary air furnace gas to mix was stirred, so that the furnace flue gas to create a vortex, extending the suspended fly ash and fly ash the stroke of the combustible material in the furnace, the fly ash and fly ash combustibles further reduced. Its rational use can make the reduced amount of fly ash, the fly ash combustibles reduced. In addition to the supply part of the suspended combustible air conducive mentioning

Related Dissertations

  1. Experimental Study on Pyrolysis and Combustion Characteristics of Paint and Tar Based Single Hazardous Wastes,X705
  2. Pattern Classification of Combustion Modes in Scramjet,V235
  3. Study on the Heat Transfer Characteristics of Particle Cluster in Circulating Fluidized Bed,TK124
  4. Experimental Study on Combustion Characteristics of Corn Straw in a Fixed Bed,TK16
  5. Numerical Simulation of Biomass Direct Reburning,TK16
  6. Numerical Simulation on Pulverized Coal Combustion Process in a 670T/H Tangential Firing Furnace,TK224.11
  7. Characteristic Study of Combustion in Central Reverse Flame Chamber,TK223.21
  8. Process Support Vector Machine and Its Application to Satellite Thermal Equilibrium Temperature Prediction,TP183
  9. Experimental Study and Analyses of O2 -CO2 Production Based on Chemical Looping Method,O611.3
  10. Cobalt Ferrite and Its Performance,O611.4
  11. Coal-fired Power Plants Denitration Transform Research and Practice,X701
  12. Synthesis of Carbon Nanotubes/ Titanium Dioxide Composite Photocatalyst by Fluidized Bed Chemical Vapor Deposition (FBCVD) and Its Photocatalytic Properties,TB383.1
  13. Performance Model of Large-scale Combined Cycle Units and Combustion Optimization Adjusted Analysis,TM611.31
  14. Adsorption Reaction Mechanism of the Flue Gas Mercury on SCR Catalyst,X773
  15. Research of High Volatage Repetition Rate Nanosecond Pulse Generator,TM832
  16. The Research and Design of a Fire Detection System Based on Combustion Audio Recognition,X924.4
  17. Thermodynamics and Kinetics Study of the Effect of Alkali Metals on Homogenous Mercury Oxidation during Co-Combustion Coal with Biomass,TK16
  18. Basic Research on the Performance of a Free Piston Linear Alternator,TM314
  19. Synthesis of Mn-Zn Ferrite by Sol-Gel Auto-Combustion Method and the Study on Properties,TM277
  20. Modified LaMnO 3 perovskites for catalytic combustion of low concentration methane,O643.36
  21. Blue phosphor for PDP SrMgAl 10 O 17 : Eu 2 of combustion synthesis , surface modification and luminescence properties of,TN104.3

CLC: > Industrial Technology > Energy and Power Engineering > Steam Power Engineering > Steam boiler > Various types of boilers
© 2012 www.DissertationTopic.Net  Mobile