Dissertation > Excellent graduate degree dissertation topics show

Design Research on the Terminal Spine of Crts Ⅱ Ballastless Track Slab on the Connecting Section of Bridge and Tunel

Author: ZhangShengYan
Tutor: WangPing
School: Southwest Jiaotong University
Course: Road and Railway Engineering
Keywords: CRTSⅡslab ballastless track transition section of bridge and tunnel friction slab terminal spine
CLC: U213.244
Type: Master's thesis
Year: 2011
Downloads: 62
Quote: 0
Read: Download Dissertation

Abstract


Because ballastless track has advantage of high stability, less maintenance workload and relatively mature technique and so on, the wide use of ballastless track on the high-speed railway becomes the development trend in the worldwide, specially, it is general for the slab track.In china, the slab track is used in some passenger dedicated lines. But the researches relate to structure design, construction method and later maintenance, and specially the technique of the slab track used in the transition section and special sections are required to be further in-depth study, and gradually improve its economic efficiency.In this paper, CRTSⅡslab track used in the special section of Beam Bridge-Tunnel-Continuous Beam Bridge is the research object, a spatial model of line slab bridge is established to analyze and calculate the force and displacement of the bridge, the slab, and the rail under the action of temperature strength and braking force. The optimal design of the terminal spine can be obtained. Finally, the friction slabs of different length and different friction coefficients were analyzed in the paper, obtaining the reasonable value in the special section.The conclusion:By comparison of several programs, only one terminal spine is needed in the tunnel in the case of temperature force. Because of the impact of temperature change which results in transition section in rail in the entrance and exit of tunnel, where additional force will suddenly increase, the maximum displacement of the rail and the jointed slab occurred in the center of the tunnel. Therefore, the connection of the regions has to be re strengthened in the design, which can ensure that there is no larger alignment irregularity. However, in the case of braking force, it is necessary to design two terminal spines so that the longitudinal force of the whole structure can be distributed uniformly. Finally, the paper analyzes the magnitudes and distribution regularities of maximum longitudinal forces of the rail, track slab and piers changing some parameters such as the length and coefficient of friction slab and the stiffness of terminal spine, through which appropriate length of the friction slab is 50m. the friction coefficient is 0.8.

Related Dissertations

  1. Influential Factors Analysis of Longitudinal Force on Bridges with CRTS Ⅱ-Type Slab Ballastless Track,U213.244
  2. High Speed ??Rail CRTS Ⅱ type of slab track -side end barbed spines and temporary mechanical characteristics of,U213.244
  3. Influential Factors Analysis of Longitudinal Force on Bridges with CRTS Ⅱ-Type Slab Ballastless Track,U213.244
  4. High Speed ??Rail CRTS Ⅱ type of slab track -side end barbed spines and temporary mechanical characteristics of,U213.244
  5. Study on the Dynamic Characteristics of the Ballastless Track with Sleeper Embeded on Bridge,U213.244
  6. Study of Economical Efficiency for the Ballastless Track of High-Speed Railway in Our Country,U213.244
  7. Study on Structure Parameters of Low Vibration Track on 250km/h PDL,U213.244
  8. Study on Application of Ballstless Track Twice-prestressed Concrete Composite Beam,U213.244
  9. Study on the Key Technologies of Construction Quality Control of High-Speed Dedicated Line Bi-block Ballastless Track from Wuhan to Guangzhou,U213.244
  10. Study on Ballastless Track Construction Technique,U213.244
  11. Study on Mechanical Characteristics of CRTS Ⅲ Type Slab Ballastless Track,U213.244
  12. Study on the Effect of the Differential Settlement of Subgrade on the Mechanical Properties of Ballastless Track in Switch Area,U213.244
  13. The Mechanics Characteristics of Ballastless Track on Bridge during Earthquakes,U213.244
  14. Study of the Key Technologies of High-speed Ballastless Track Construction and Dynamic Characteristics of the Standard Span Bridge,U213.244
  15. The Stress Analysis of Simulation and the Fatigue Life Estimate of the Rheda2000 Ballastless Track Slab,U213.244
  16. Design and Construction of Ballastless Track on Subgrade in Sui-yu Railway,U213.244
  17. Vertical Length Pillow Ballastless Track Analysis of Mechanical Properties,U213.244
  18. Optimization Research on Terminal Structure of Ⅱ-type Slab Ballastless Track on Long-span Continuous Beam Bridge,U213.244
  19. The Vertical Dynamic Analysis of Bi-Block Ballastless Track on Soil Formation,U213.244
  20. The Application of the Precisely-Measuring Technique in the Construction of the Ballastless Track,U213.244

CLC: > Transportation > Rail transport > Railway Line Project > Line constructed > Track > New rail foundation > Ballasted track
© 2012 www.DissertationTopic.Net  Mobile