Dissertation > Excellent graduate degree dissertation topics show

Synthesis of LiFePO4 by Solid-state Method and the Modification Research

Author: QiuRuiLing
Tutor: TangZhiYuan
School: Tianjin University
Course: Applied Chemistry
Keywords: Lithium ion battery Catohde material Lithium iron phosphate Solide state method Carbon coated Doping
CLC: TM912
Type: Master's thesis
Year: 2008
Downloads: 349
Quote: 2
Read: Download Dissertation

Abstract


Lithium iron phosphate, LiFePO4, has recently attracted significant interest because of its high safety, low cost, high stability at a high temperature, environmentally friendly components and preferred cathode material for lithium-ion power batteries. The conductivity and the ion diffusibility of LiFePO4 are poor due to the restriction of its crystal structure, so the practical specific capacity is low and the discharge performance at high rates is poor. The modification research is focused on the enhancement of the conductivity and the ion diffusibility.In this paper, the starting materials were mixed by ball milling, LiFePO4 cathode material was prepared by solid-state method and modified by carbon coating and Mg2+ doping, and meanwhile, the electrode technology of LiFePO4 was studied. The preparation technology, modification, structure characterization, electrochemical performance and electrode preparation technology were investigated by using TG-DTA, XRD, SEM, CV, EIS and charge-discharge tests.The results shows that:the grains of the carbon coated LiFePO4 is smaller and distributed uniformly for the carbon which can prevent the oxidation of Fe2+ and the agglomeration of the grains as a nucleating agent; the tap density is reduced greatly as the increasing carbon contents; the carbon content and the sintering temperature have obvious influence on the electrochemical performance of LiFePO4, when the carbon content is 6% and the sintering temperature 650℃, the obtained has best performance with the specific capacity of 143mAh g-1.Mg2+ doped LiFe1-xMgxPO4/C was obtained based on carbon coated LiFePO4. The LiFe1-xMgxPO4/C has higher specific capacity, flatter potential platform and better cycle performance. The specific capacity of LiFe1-xMgxPO4/C is enhanced firstly and then is reduced as the increasing contents of Mg2+. When the doping content equals 0.04, the obtained has the best electrochemical performance with a specific capacity of 153mAh g-1.The electrode preparation technology has important effect on the performance of the LiFePO4 cathode material, such as the adhesive contents, the conductive agent and the electrolyte. The proper adhesive content is 6% and the proper conductive agent content is 15%. The electrolyte with three components of organic solvents （EC:DEC:DMC= 1:1:1） has better performance at a relative lower rate （0.1C）, while the electrolyte with two components of organic solvents （EC:DMC=1:1）has better performance at a relative higher rate （1C）. The performance of LiPF6 is much better than that of LiBF4.

Related Dissertations

  1. Preparation and Photocatalytic Properties for Water Decomposition of Titanate Photocatalyst,O643.36
  2. Preparation and Properties of Silicon Carbon Anode for Lithium Ion Battery,TM912.9
  3. The Study of Preparation and Photocatalytic Activity of TiO2 by Electrospinning,O614.411
  4. Study and Preparation of BaTiO3-based NTC Ceramic Thermistors,TQ174.1
  5. First- principles calculations of doped anatase titanium dioxide photocatalytic properties,O643.36
  6. Preparation of One-dimensional Nano TiO2 and Study on the Decolorization of Dyeing Wastewater,TB383.1
  7. First-Principles Studies of Cathode Material LiMO2 （M=Co, Ni, Mn） of Lithium Ion Batteries,TM912
  8. Iron, lanthanum -doped nano TiO \u003csub\u003e 2 \u003c/ sub\u003e Preparation and photocatalytic properties,O614.411
  9. Influence of Doping Effect on Zinc Oxide by First Principles Studies,O614.241
  10. Investigation of Sensitivity of Conductive Fabric Knitted by CCFS,TS186
  11. Doped Modification and Application of Titania Photocatalyst,O643.36
  12. Preparation and Properties of Crystalline Glaze for Low Temperature and Fast Firing,TQ174.65
  13. Research on Luminescence of Nanoporous Glass Composite Materials,TB383.1
  14. Preparation of Zeolite Doping Nano-TiO2 and Research of the Photocatalytic Properties,TB383.1
  15. Preparation and Characterization of Doped BiFeO3 Nanocrystals,TB383.1
  16. Study on Low Temperature Sintered PSN-PZT Piezoelectric Ceramics,TM282
  17. Preparation and Properties of ZnO-based Diluted Magnetic Semiconductors,TN304.21
  18. Synthesis and Modification of Cathode Materials LiFePO4 and Li2FeSiO4 for Lithium Ion Battery,TM912
  19. Synthesis and Modification of Nano LiFePO4 as Cathode Materials,TM912
  20. Study on Synthesis and Modified of LiFePO4 as Cathode Materials,TM912
  21. Preparation and Research Electrochemical Properties of LiFePO4 for Cathode Material of Lithium-ion Batteries,TM912

CLC: > Industrial Technology > Electrotechnical > Independent power supply technology (direct power) > Battery
© 2012 www.DissertationTopic.Net  Mobile