Dissertation > Excellent graduate degree dissertation topics show

Numerical simulation of micro- air boundary layer vortex generator control problem

Author: WuYong
Tutor: XuCheng
School: Nanjing University of Technology and Engineering
Course: Artillery , automatic weapons and ammunition Engineering
Keywords: Vortex Generator Jet Reynolds Stress Boundary Turbulence Jet
CLC: TB126
Type: Master's thesis
Year: 2002
Downloads: 239
Quote: 1
Read: Download Dissertation

Abstract


A computed study was undertaken to determine the effects of minute vortex generator jets on the zero pressure gradient turbulence boundary layer. The computed problem was the same as the experimental problem of Cheng Xu and K Eaton in 1997. Navier-Strokes equation was solved using SIMPLE method. LAM-Bremhorst K-E was used to simulate turbulent flow.It was indicated in this thesis that a longitudinal vortex would be produced after the jet exhausted from a plate into a boundary layer at a pitch angle and a skew angle. In the boundary, velocity and Reynolds stress was distorted greatly by the vortex that leaded to an upwash domain and a downwash domain. The effects of jet velocity ratio and skew angle were addressed. Several co-rotating minute vortexes on the turbulence boundary layer would coalesce together that leaded to a big vortex. The effect of the big vortex was greater than a single minute one. For several vortex generator jets, the spacing of them was an important factor of effect.

Related Dissertations

  1. Influence of over Fired Air on Gas-Solid Flows in a W-Shaped Flame Boiler,TK229
  2. Fabrication of Membrane Electrode Assembly for PEMFC,TM911.4
  3. Fractional Differential resonance boundary value problems,O175.8
  4. Optimization of Local Structure and Analysis of Jetting Performance of Main Nozzle in an Air-Jet Loom,TS103.337.1
  5. Solutions to the Second Order Ordinary Differential Equation Periodic Boundary Value Problems,O175.8
  6. Existence and Multiplicity of Solutions for φ-Laplacian Equations,O175.8
  7. The Study on Modeling and Simulation of Infrared Lidar to Measure Methane Concentration,TN958.98
  8. Positive Solutions of Second Order Boundary Value Problems for Singular Differential Equations and Differential Systems,O175.8
  9. Study on a Class of Sturm-Liouville Boudary Value Problems,O175.8
  10. Development of Online Classifying System for Shaped Floor Ceramic Tiles Based on Image,TP391.41
  11. Homogeneous charge compression ignition combustion HC and CO generated Mechanism Testing,TK401
  12. Continuous hot dip galvanized strip stable transmission , heat transfer and organizational change behavior,TK124
  13. Hydrogenated nanocrystalline silicon photovoltaic materials in hydrogen bonding defects in material structure and the impact of,TB383.1
  14. Study on Turbulence Development of Abrasive Flow in Large Curvature Structural Surface,TG73
  15. Constraint modules on flexible abrasive flow finishing processing applications and design methods,TG664
  16. ECAP auxiliary copper grain boundary engineering research,TG146.11
  17. Multiprocessor rate monotonic scheduling algorithm,TP332
  18. Powerful jet vortex spinning influencing factors and related technology research,TS104
  19. Polyester and viscose blended yarn MVS yarn spinning process and its impact on the performance and structure of,TS104
  20. Research on linear plasma jet,O53
  21. Nan Crime Research,D924.3

CLC: > Industrial Technology > General industrial technology > Engineering and basic science > Engineering Mechanics > Engineering Fluid Mechanics
© 2012 www.DissertationTopic.Net  Mobile