Dissertation > Excellent graduate degree dissertation topics show

The Study and Design of White LED Driver Based on DC-DC Technology

Author: BanZuo
Tutor: ZhangHongNan；GongYuePing
School: Hunan University
Course: Electronics and Communications Engineering
Keywords: charge pump voltage reference oscillator amplifier white LED
CLC: TN312.8
Type: Master's thesis
Year: 2009
Downloads: 313
Quote: 0
Read: Download Dissertation

Abstract


The white light-emitting diode (LED), as a high-quality backlight source, has been used widely in the portable electronic products. The charge-pump technology has been one of the best choices of the LED driver, due to its advantages of less EMI (Electro-Magnetic Interference), lower cost and less size, especially because of its promising prospects of larger output current, lower output resistance and higher efficiency. In this thesis, a LED driver based on the constant-current charge-pump circuits has been designed and realized. The driver would be applied in the cell phones, the digital cameras, the MP3 players and other portable electronic products.The self-adaptive have been introduced in the driver in order to assure the highest output efficiency in the whole scope of input voltage. The current of each LED can be adjusted independently by its corresponding current regulator so that the current matching and the emission intensity uniformity can be obtained easily. The full scale LED current would be determined by an external resistor, which improves the flexibility of the driver. The LED brightness could be controlled by the digital input signals, which results in the possibility of the continuous adjusting of the LED lightness and enlarges the application of the driver. In addition, the circuits own the functions of soft start and over temperature protection, and so on.In this thesis, the theory about the driver and the circuit diagram are introduced firstly. Then the charge-pump technology and its key parameters are discussed, and some methods of LED constant current driving and brightness regulating are analyzed. The four sub-blocks, including the bandgap reference circuit, the operational amplifier, the oscillator and the over-temperature protection circuit are designed respectively. The whole chip functions and the key performances are simulated and the results show that the LED driver has achieved the design specification. Finally, we design the layout of the chip and test its performance after tape out of the chip.

Related Dissertations

  1. Research and Improvement of Multi-Level Modulation Self-Adaptive Digital Predistortion Algorithm,TN722.75
  2. Design of Digital Predistorter for RF Power Amplifier Based on FPGA,TN722.75
  3. Research of Acoustic Signal Acquisition System Based on DSP,TP274.2
  4. The Research of Chaos M-ary Modulation and Demodulation Method Based on Chaotic Oscillator,TN915.05
  5. Research on Power Supply of Contactless Power Transfer System,TM46
  6. Design Power Amplifier of Basestation and Study on Predistortion System,TN722.75
  7. Based on the study of all-optical logic gates for fiber nonlinear effects,TN253
  8. Synthesis and Properties of Rare Earth Red-emitting Phosphors for White LED,O482.31
  9. Analysis and Design of Low-Noise Charge-Pump PLL,TN911.8
  10. Performance Research and Theoretical Design of Visible Light LED Communication System,TN929.1
  11. The Circuit Design and Implementation of the Sense Amplifier in Nano-Crystal Memory,TP333
  12. Study on Metal Detector Based on Doppler Effect,TN702
  13. The High Voltage Generation System Design in Nano-Crystal Memory,TN47
  14. A High-Performance Audio ∑△ ADC in 65nm CMOS Process,TN792
  15. Research on FBAR and Its Oscillator,TN752
  16. SiO 2 microspheres as the precursor of the white LED phosphor synthesis and properties of,TN104.3
  17. 100-400MHz broadband power amplifier design and implementation,TN722.75
  18. Liquid crystal tunable filter spectral transmittance Test System,TN713
  19. Magnetic -type Hall sensor chip offset and noise cancellation technology research,TP212
  20. YAG: Ce 3 Preparation and luminescent properties of phosphor,TQ422
  21. The Implementation of DWDM Optical Terminal Multiplexerstation,TN929.1

CLC: > Industrial Technology > Radio electronics, telecommunications technology > Semiconductor technology > Semiconductor diode > Diodes: structure and performance > Light-emitting diodes
© 2012 www.DissertationTopic.Net  Mobile