Dissertation > Excellent graduate degree dissertation topics show

Preparation, Characterization and Corrosion Resistance of Cr-Pd Alloy Films on 316L Stainless Steel by Electrodeposition

Author: XuLiang
Tutor: ZuoYu
School: Beijing University of Chemical Technology
Course: Materials Science and Engineering
Keywords: stainless steel electrodeposited films Cr-Pd alloy corrosion resistence passive film trivalent chromium
CLC: TG174.4
Type: Master's thesis
Year: 2010
Downloads: 184
Quote: 1
Read: Download Dissertation

Abstract


Cr-Pd alloy films with good corrosion resistance, high hardness has been recently developed as a kind of new and protective membrane, To optimize the electroplating process, conductive salt and additive of the bath were studied. Based on the single factors study, the optimal composition formula was obtained by an orthogonal method. And with the optimal formula, the influence of bath composition and operating conditions on the properties of solution and coatings was studied.An uniform chromium-palladium film on 316 stainless steel was obtained by electroless plating. Scanning electronic microscopy, x-ray photoelectron spectroscopy, weight loss tests and electrochemical measurements were used to character the properties of the film. Corrosion behaviors of the chromium-palladium plated samples in acetic and formic acid mixtures at boiling temperature and the 20% sulfuric acid were studied. Finally, the reasons of the chromium Palladium alloy films enhance the corrosion resistance of 316L stainless steelwere discussed. The electroplated films were mainly composed of chromium and palladium. In the Cr-Pd films both Cr and Pd presented mainly in metallic state, with the grain sizes less than 100 nm. The Cr-Pd plated sample showed higher microhardness than Pd plated sample and 316L stainless steel. On the surface, Cr(OH)3 and Cr2O3 were present. The crystallite size decreased with the increase of Pd content in the Cr-Pd alloy films. The adhesive strength was examined by cross-cut tape test, thermal shock test and Cross-cut tape test, and the adhesion of the film to stainless steel was quite good.In boiling 20% H2SO4 solution, corrosion rates of the Cr-Pd plated samples were about four orders of magnitude lower than that of the original 316L stainless steel samples. With the increase of chromium content in the Cr-Pd films, corrosion potential of the Cr-Pd plated stainless steel samples decreased, but the impedance of the film increased.

Related Dissertations

  1. Environmental Effects of Poisonous and Harmful Substances in the Typical Industrial Solid Wastes,X705
  2. Study of the Preparation and Properties of the Trivalent Chromium Black Passivation with Non-cobalt Sulfate System,TG174.4
  3. Several Ladles Pouring Together for Large Super-low-carbon Stainless Steel Casting,TG260
  4. Stainless steel fuel cell bipolar plate and its experimental and simulation,TM911.4
  5. Shandong LWGT’ Shot-rolled Annealing and Pickling Line Feasibility Study,F426.3
  6. Research of Microalloying Nb and Ti in Ultra-purity 430 Ferritic Stainless Steel,TG142.71
  7. Technology of Effective Trivalent Chromium Plating,TQ153.1
  8. 316L stainless steel surface nanocrystallization mechanisms of fatigue analysis,TG142.15
  9. Study on Drawing of Stainless Steel Bend,TG386
  10. Study of Microstructure, Texture and Formability of Ultra-purified Cr12 Ferritic Stainless Steel,TG142.71
  11. Study of Deformation Law in Titanium Alloy-Stainless Steel Vacuum Hot Rolling Bonding,TG335.11
  12. Strength、 Buckling and Fatigue Strength of Researching on Stainless Steel Bodywork of Type A Metro,U270.1
  13. Corrosion Resistance of Nickel Free High Nitrogen Austenitic Stainless Steel,TG142.71
  14. Research on Microstructure and High-temperature Oxidation Property of Al-Si Coatings on 1Cr11MoNiW1VNbN Stainless Steel,TG174.44
  15. The High Temperature Oxidation Properties of Gradient Nano (Ti, Al) N Coating on 1Cr11Ni2W2MoV Stainless Steel,TG174.44
  16. Research on the Precipitated Phase of 25Cr-5Ni-Mo-N Duplex Stainless Steel,TG142.71
  17. 445M ferritic stainless steel performance,TG142.71
  18. Cr15 super martensitic stainless steel electrochemical corrosion behavior,TG172
  19. Stainless steel multi-channel laser cladding Ni -based coating stress field analysis and numerical simulation,TG174.4
  20. Research on the Mechanism of Electrochemically Induced Surface Annealing in Stainless Steel and Improvement of the Technique,TG174.4
  21. Fabrication and Characteristic of Ceramic Coatings on Stainless Steel Substrates,TG174.453

CLC: > Industrial Technology > Metallurgy and Metal Craft > Metallurgy and Heat Treatment > Metal corrosion protection,metal surface treatment > Corrosion control and protection > Metal surface protection technology
© 2012 www.DissertationTopic.Net  Mobile