Dissertation > Excellent graduate degree dissertation topics show

The Research of Low Output Ripple Power Converter for Laser

Author: FengZhuoMin
Tutor: QianZhaoMing
School: Zhejiang University
Course: Power Electronics and Power Drives
Keywords: laser diode low ripple constant-current source interleave coupled inductor
CLC: TN248.4
Type: Master's thesis
Year: 2010
Downloads: 205
Quote: 0
Read: Download Dissertation

Abstract


Laser technology is one of the four great inventions in 20th century. It gives the traditional optical science a new life and leads a new industry rise. It has a broad application in various areas of the national economy now. This paper pays attention to the research and design of laser diode driver. The design process of traditional lasers will be introduced. And this paper will analyze and discuss the power converter which is able to be used as lasers driver.Because of the laser with high brightness, better in direction, color and coherence, it is widely used. First of all, the backgrounds on the application of laser diode are introduced. And the character of laser diode and its requirement for the drivers are shown. Upon review of the literature at home and abroad, detail analyzed for the strengths and weaknesses of existing programs will be given.Considering the requirement of stability and reliability to the system, the laser driver is used of linear power supply usually. But the low efficiency of linear power will lead to increase the size and weight of the system, which will affect to some portable application and also make energy waste for extensive use of lasers. In Chapter II, the reasons for the formation of the ripple and the ways to remove will be introduced. And the direction and difficult in researching power supply for laser driver will be discussed.In Chapter III, the way to design traditional laser driver will be introduced. And the experimental results will be shown in this part. Detail analyzes for the advantages and limitations will be given.In Chapter IV, this paper introduces the applications of coupled inductors in power supply to reduce ripple, and the principles is given. An input and output ripple free converter with a four-winding coupled inductor will be introduced. This part will analyze the influence and role of coupled inductor in ripple cancellation and system dynamics.In order to overcome the short of linear power, in Chapter V, a two current quadrant converter with low current ripple by using coupled inductor is proposed. Detail theoretical analyzes and the experiment results are given in this chapter.This work is sponsored by Science and Technology Planning Project of Zhejiang Province, China. Project No: 2009C31005. Base theoretical study and a feasibility scheme are the primary work of this paper. It is the base of this project.

Related Dissertations

  1. Erbium-doped fiber amplifier pump laser drive source research applications,TN248
  2. Labview-based PCR chip temperature control system,TP274
  3. Research of Key Technologies of Stabizing LD in Gas Detection System,TN248
  4. Intensity Distribution Investigation and Beam Shaping about the Laser Diode Array,TN248.4
  5. Design of Digital Driver for Single-Mode Semiconductor Laser Pump Sources,TN248.4
  6. The Study of Yb: YAG Thin Disk Laser,TN248
  7. Thermal Analysis of Laser Chip with Different Sise Based on C-Mount Packaging,TN248.4
  8. Research and Design of low ripple and high efficiency switched-capacitor DC-DC converter,TM46
  9. The Research on All-solid-state Cw Single Frequency Nd: YLF Laser,TN248
  10. Research on Multi-Output Power Supply Applied for Broad-Band Equipment,TM46
  11. Research on Multiphase Interleaving Voltage Regulator Module of Planar Integrating Magnetics,TM46
  12. A Novel Coupled-Inductor for Interleaved Converters,TM461
  13. Study on Single Phase Active Power Factor Correction Converter with Low-ripple,TM46
  14. IF power single-phase power factor correction method,TM46
  15. Study on the Transition Process of Closing Shunt Capacitors in 10kV Power System,TM531.4
  16. Research on Topology and Control Strategy on A Novel Single Stage Boost Inverter,TM464
  17. The Research on a Subminiature Power for PZT Supply with Low Output Ripple,TH703
  18. Analog street light control system design,TP273
  19. 4-Channel Charge Pump White LED Driver Design,TN312.8
  20. Research on Constant- Current Source Biased Magnetic Bearing System,TH133.3

CLC: > Industrial Technology > Radio electronics, telecommunications technology > Photonics technology,laser technology > Laser technology, the maser > Laser > Semiconductor lasers
© 2012 www.DissertationTopic.Net  Mobile