Dissertation > Excellent graduate degree dissertation topics show

Electronic Packaging diamond / copper composite materials

Author: ShangQingLiang
Tutor: ZhuXinKun
School: Kunming University of Science and Technology
Course: Materials Science
Keywords: diamond/Cu composites repressing and re-sintering technology relative density coefficient of thermal expansion thermal conductivity
CLC: TB333
Type: Master's thesis
Year: 2009
Downloads: 152
Quote: 1
Read: Download Dissertation

Abstract


With the development of microelectronics and semiconductor, diamond/Cu compsoites as a new generation electronic packaging materials have received more and more attension. Diamond/Cu composites have more outstanding performance than the traditional electronic packaging materials.The have the most development potential to be the new generation electronic packaging. The research of diamond/Cu composite is of great theoretical and practical value.In this experiment, different diamond volume fraction (50vol.%,60vol.%,70 vol.%) of diamond/Cu were prepared by repressing and re-sintering technology of powder metallurgy under the condition of different fabrication process parameters, during the process, the diamond particle size of20μm,40μm,90μm was selected.The relative density of composites were measured and analyzed. The results showed that the relative density of composites elevated with increasing compacting pressure, but over 1500MPa, the compacting pressure didn’t have so much influence on the relative density; At 890℃, the relative density of composites reached the maximum. but over 890℃, the relative density of composites began to decreasing with increasing sintering temperature due to the graphitization; Proper longer sintering time could contribute to improve the relative density; The relative density of composites heightened with the increasing of diamond particle size and reduced with the increasing of the volume fraction of diamond.The coefficient of thermal expansion of the composites were tested and analyzed. The study demonstrated that the coefficient of thermal expansion increased with the diamond particle size increased and the volume fraction of diamond reduced. At the same time, the coefficient of thermal expansion of the diamond/Cu composites was theoretical calculated according to the ROM model, Turner model and Kerner model.The thermal conductivityof the composites were tested and analyzed according to theoretical model. The results showed that the thermal conductivity elevated with the increasing of the relative density of composites、diamond particle size; the thermal conductivity decreased with the increasing of the volume fraction of diamond which were opposite to the theoretical calculation by using Geometric average model, Maxwell model and P.G. Klemens model. Due to the lower relaive density, The thermal conductivity of composite perared by the repressing and re-sintering technology was only 62.8 W/(m-K) which had some distance to the reported results of overseas referrence and expected goals.The diamond/Cu composites of 70vol.% diamond were prepared with optimized process, the relative density could be gained as 83% probably. and the coefficient of thermal expansion 6.4～7.5×10-6/K at 100℃.

Related Dissertations

  1. Study on the Dynamic Thermal Test Device of Sprinklers,TU892
  2. Relationships between Thermo-physical Properties and Physiological and Biochemical Parameters of Fruits and Vegetables and Neural Network Prediction Model on Thermo-physical Properties,TS255.1
  3. Research on the Preparation and Properties of Insulation Board Made by Silicon Calcium-Expended Perlite,TU551
  4. The Influence of the Hot-press Shear Rheology Technology on the Thermal Conductivity of Carbon Materials,TB332
  5. Thermal Conductivity and Electrical Insulation of Unsaturated Epoxy/Aluminum Nitride Composites,TQ323.5
  6. The Preparation and Properties of Carbon Foam and Its Composite,TB332
  7. Microstructure and Properties of 9Cr-ODS RAFM Prepared by PM,TG142.1
  8. The Experimental Research on Measurement of Thermal Contact Resistance of Two Contacted Solids and Thermal Conductivity,TK124
  9. Study on Properties of Micro-Scale Flow and Heat Transfer Within the Porous Electrode of SOFC,TK124
  10. Nanoparticle Tio 2 Dispersed Composite Phase Change Material for Energy Storage in Air-conditioning,TB383.1
  11. Research on Effects of Transition Metal Oxides on Thermal Conductivity of Mold Fluxes,TF777
  12. Research on the Composite Silicate Thermal Insulation Material for External Wall,TU551
  13. Heat and Mass Transfer Characteristic of Compound Adsorbents for Adsorption/desorption Process,TB61
  14. Variable conditions in orbit, the spacecraft solar wing thermal - structural analysis,V442
  15. High thermal conductivity epoxy composites and Research,TB332
  16. Research on the Fabrication of Ultrafine Carbon Fibers and Its Thermal Properties,TQ342.742
  17. Fabrication and Mechanical Properties of Pyramidal Lattice Truss Sandwich Structures of Aluminium Alloy,TB383.4
  18. Research of Clustering Algorithm Based on Relative Density,TP311.13
  19. Study on the Physical Process of Icing on Fixed Wires by Multiphase Flow Theory,O359
  20. Properties of β-SiC_p/Al Electronic Packaging Material Fabricated by Pressureless Infiltration,TN604
  21. The Studies on Thermal Shock Test of WC Particles Reinforced Steel Substrate Surface Composites,TB331

CLC: > Industrial Technology > General industrial technology > Materials science and engineering > Composite materials > Metal - non-metallic composite materials
© 2012 www.DissertationTopic.Net  Mobile