Dissertation > Excellent graduate degree dissertation topics show

Design of an On-chip 10-bit 20-Msample/s 49mW Pipelined A/D Converter

Author: TangYongJian
Tutor: HeLeNian
School: Zhejiang University
Course: Circuits and Systems
Keywords: Pipelined ADC S/H Circuit Op-amp Comparator
CLC: TN792
Type: Master's thesis
Year: 2005
Downloads: 336
Quote: 12
Read: Download Dissertation

Abstract


In a mixed signal system, the ADC (Analog-to-Digital Converter) is always an indispensable component. Compared to other architectures, the pipelined architecture ADC is creditable for its high speed and high resolution. Generally speaking, it’s reasonable to adopt the pipelined architecture for the ADCs whose resolution is 10-bit or more and sampling rate is above 1MS/s.This thesis focuses on the research of a high performance and low power Pipelined A/D Converter which is fabricated in a 0.6pm double-poly double-metal CMOS process. The digital correction technique is used to relax the offset requirement of the comparators. To reduce signal-dependent charge injection and substrate noise injection, the bottom-plate sampling technology is applied. A sample-and-hold amplifier (S/H Circuit) is also used to improve the signal-to-noise and distortion ratio (SNDR) performance and the linearity of ADC. The circuit is simulated by the Hspice software which is based on CSMC’s library of 0.6μm mixed-signal CMOS model. The simulation results reveal that the ADC designed with this method achieves the SNDR of 58dB at full speed of 20MHz when input frequency is 4.125MHz. Furthermore, the ADC consumes 49mW power at 5V supply voltage with a low power operational transconductance amplifier (OTA) and the dynamic comparators.

Related Dissertations

  1. Research on the Aiming Signal Processing of the Optical Probe Measurement System,TH74
  2. The Technological Parameter Analysis and Influencing Factor Research on RUV4 Automobile Ignition Coils,U463.64
  3. Numerical Analysis of Flow Process in a Molten Carbonate Fuel Cell,TM911.4
  4. The Equivalent Circuit Model of Radial Vibration Mode Piezoelectric Transformer and Its Application,TM406
  5. Research on HID Lamp Rectifying Effect,TM923.32
  6. Research on the Effect of Electrodes and Electrolyte on H2O2 Open Circuit Potential,TM911.4
  7. Design and Realization of the Magnetic Antenna in MW and SW Bands Based on Genetic Algorithm,TN820
  8. Design and Study of a New Wind Generator,TM315
  9. Researches on the Application of the Neuron-MOS in the Neural Network,TP183
  10. Studies on Asynchronous Multiplier Design and Research Techniques Based on Macro Cell,TP332.22
  11. Buck type AC chopper regulator of,TM46
  12. Solar LED street light control system design and production,TP273
  13. Indoor air purifiers developed high voltage power supply,TN86
  14. Composite cage rotor induction motor starting performance of the design and research,TM343
  15. 126kV Vacuum Circuit Breaker Dynamic Simulation and Design,TM561.2
  16. Brushless DC Motor Based on DSP Control System institutions,TM33
  17. Composite moving target detection time domain signal processing technology research,TN911.7
  18. 40W LED driving circuit and control circuit design,TM923.34
  19. Study on On-chip Electrochemical Sensing System,TN792
  20. Study on Drive Section of Integrated Gate Commutated Thyristor,TN34
  21. Research and Design of Bandgap Reference Voltage Source Using 0.5-micron CMOS Process,TN432

CLC: > Industrial Technology > Radio electronics, telecommunications technology > Basic electronic circuits > Digital circuits > Digital-analog , digital to analog conversion circuit
© 2012 www.DissertationTopic.Net  Mobile