Dissertation > Excellent graduate degree dissertation topics show

Synthesis and Carbon Composites of LiFePO4 as Cathode Material for Lithium-ion Battery

Author: JiaoJian
Tutor: YangShaoBin
School: Liaoning Technical University
Course: Materials Science
Keywords: lithium ion battery cathode material olivine-LiFePO4 solid-state synthesis
CLC: TM912
Type: Master's thesis
Year: 2008
Downloads: 258
Quote: 1
Read: Download Dissertation

Abstract


The increasing concerns on energy, environmental and the rapid development of modern science and technology have more demands on batteries. Lithium ion batteries （LIB） are attractive for use in the field of mobile power source with the favorable properties of high voltage, long cycling life, high energy density, non-memory effect and pollution-free. Intensive research is being conducted to further improve the performance of lithium ion batteries and reduce the cost of electrode materials.Because of its high theoretical capacity （170 mAh/g）,and feasible voltage （about 3.5V versus Li+/Li）, good stability both at room temperature and high temperature, and being environmental benign and inexpensive, LiFePO4 is very hopeful material as positive electrode materials for the future lithium-ion batteries material. However, inhering limit from that in the layered and spinel structures, resulting in a extremely low electronic conductivity, which has been the greatest obstacle for application of lithium ion phosphate. When current density increases, its reversible capacity drops dramatically.On the base of reviewing the development of lithium ion battery and its cathode materials in detail, olivine LiFePO4 were chosen as cathode material and their synthesis and modification were studied. In this paper LiFePO4 powders were prepared via solid-state reactions mehtod that involve multiple steps at hightemperatures. The effects of synthesis conditions on structure and electrochemical behavior of LiFePO4 were studied. Meanwhile the modified materials were also conducted on the basis of LiFePO4 material. In addition, we used X-Ray Diffraction （XRD） to analyze phase composition, Scanning Electron Microscope （SEM） to observe superficial morphology, charge-discharge test to study specific capacity.The results show that an 300r/min the milling parameters, the sintering temperature of 650℃, and the holding time for 8 h, prepared by high-temperature solid-phase of the carbon-doped materials LiFePO4 has good structure and electrochemical properties of its first charge-discharge capacity reached 122.6 mAh/g （0.1C）. As doped carbon, organic carbon （glucose） better than the original carbon doped with secondary milling and rapid warming of synthetic material particles contribute to the growth control.

Related Dissertations

  1. Preparation and Properties of Silicon Carbon Anode for Lithium Ion Battery,TM912.9
  2. First-Principles Studies of Cathode Material Srn+1TinO3n+1（n=1,2,3,∞） for Solid Oxide Fuel Cell,TM911.4
  3. The Study of Li-rich Layered Solid-Solution Cathode Materials for Lithium Ion Batteries,TM912
  4. Synthesis and Modification of Cathode Materials LiFePO4 and Li2FeSiO4 for Lithium Ion Battery,TM912
  5. Synthesis and Modification of Nano LiFePO4 as Cathode Materials,TM912
  6. Preparation and Research Electrochemical Properties of LiFePO4 for Cathode Material of Lithium-ion Batteries,TM912
  7. New Rechargeable Magnesium Battery Cathode Material silicate Cobalt Magnesium Preparation and Properties,TM912
  8. Study of Field Emission Properties of Printed Carbon Nanotube Films,TB383.1
  9. Study on the Synthesis and Properties of LiFePO4 with Ferric Ions,TM912
  10. The Application of a Novel Ternary Molten Salt in the Preparation of LiNi0.8 Co0.2O2 and LiNi1/3Co1/3 Mn1/3O2,TM912
  11. Effect of Treatment to Precursor on Performance of LINI0.5 MN1.5O4 , Cathode Material Li-ion Battery,TM912
  12. Preparation and electrochemical properties of lithium iron phosphate cathode material,TM912
  13. Synthesis and Electrochemical Property Study of LiFePO4 as Cathode Materials,TM912
  14. Battery cathode material spherical Ni (OH) _2 preparation conditions and properties of,TM911
  15. Study on Sol-gel Spin Coating Preparation and Properties of LiNi0.5Mn0.5O2 Cathode Thin-films,O614.111
  16. Study on AC Impedance Characteristics of LiFePO4 as Cathode Materials for Lithium Ion Batteries,TM912
  17. Synthesis Methods of Lithium-ion Battery Cathode Material LiMnPO4,TM912
  18. Study on Solid-state Method and Modification of Cathode Material LifePO4 of Lithium Ion Battery,TM912
  19. Lithium- ion battery cathode material lithium iron phosphate preparation and modification,TM912
  20. Porous nano-scale lithium-ion battery cathode material lithium iron phosphate Preparation and Research,TM912
  21. The Fabrication, Structure and Properties of SnO2/Sn/C Composites Anode Materials for Lithium Ion Batteries,TM912

CLC: > Industrial Technology > Electrotechnical > Independent power supply technology (direct power) > Battery
© 2012 www.DissertationTopic.Net  Mobile