Dissertation > Excellent graduate degree dissertation topics show

Numerical Simulation and Experimental Research on an Air-Heater of Low Total Temperature

Author: LiuYouPeng
Tutor: ShenChiBing
School: National University of Defense Science and Technology
Course: Aeronautical and Astronautical Science and Technology
Keywords: Air-Heater of Low Total Temperature Numerical Simulation Spray Combustion Combustion Efficiency Ignite
CLC: V433.9
Type: Master's thesis
Year: 2010
Downloads: 26
Quote: 1
Read: Download Dissertation

Abstract


The numerical simulation and experimental research on an air-heater of low total temperature were performed to study the influences of its structural parameters and state parameters in this paper.Firstly, a physical model and numerical method are developed to simulate the spray combustion processes in the air-heater fo low total temperature.Three-dimension full N-S equations and two-phase flow model which considers the liquid fuel spray as discrete particles, are employed to describe the combustion processes. The mass and energy transfer between the two phases are calculated by the droplet evaporation model, and the gas chemical reaction rate is calculated by the Eddy-Dissipation model. The spray combustion flow in the air-heater is simulated by using the models and method founded in this thesis, the structural of combustion flow in the air-heater and the combustion efficiency on the axis of the air-heater.Secondly, the parameters that have influences on the performance of the air-heater are analysed and several comparable operations are founded. Then the numerical simulation of all operations are finished. The effect of air flow from injector-inlet, the injectors array, the direction of injectors and the combustion chamber length(Lc) on the combustion efficiency, the combustion chamber cooling and the uniformity of the outlet are analyzed based on the simulation results. The results show that, the air flow from injector-inlet has significant influences on the combustion efficiency and the cooling of injector faceplate; the inner surface of the combustion chamber is protected by air flow from chamber-inlet; the injectors array effects the cooling of injector faceplate but has light influences on the combustion efficiency; the uniformity of the outlet will become worse when Lc is reduced.Finally, observe the effect of air flow from injector-inlet on the stabilization of igniting, the combustion efficiency and the uniformity of the outlet by experiment, The results show that, when the air flow from injector-inlet is low in a range, the combustion efficiency is nearly 100% and fluctuate slightly, the combustion efficiency will decrease rapidly and the uniformity of the outlet will become worse when the air flow from injector-inlet raises out of the range, the air-heater will become unignitable when the air flow from injector-inlet is too large.

Related Dissertations

  1. The Setting Bases of Working Pressure in LNG Systems and Orthogonal Experiment Design of Heat Exchangers,TQ051.5
  2. Study on Springback of High-Strength Steel Stamping,TG386
  3. Numerical Simulation and Experiment on Hydroforming of Cups with Controllable Radial Pressure,TG386
  4. Research on Technology and Mechanism of Joining Cemented Carbide to Carbon Steel,TG454
  5. Numerical Simulation of Film Cooling in Turbine Cascade with Non-Axisymmetric Endwall Method,V231.3
  6. High Speed Aerodynamic Convection and Coupled Heat Transfer of Complicated Bodies,V215.4
  7. The Analysis on Characteris of Vibration Source about Vertical Vibration of Surrounding Environment Induced by Rail Transit,U211.3
  8. Study on the Heat Transfer Characteristics of Particle Cluster in Circulating Fluidized Bed,TK124
  9. Numerical Simulation of SNCR Process of a 600MW Utility Boiler,TK222
  10. Numerical Simulation of Biomass Direct Reburning,TK16
  11. Numerical Simulation on Pulverized Coal Combustion Process in a 670T/H Tangential Firing Furnace,TK224.11
  12. Numerical Simulation on the Combustion Process in the Furnace of a 1000MW Lignite-Fired USC Boiler,TK224.11
  13. Study on Gas-Solid Two-Phase Flow in Spouted Beds,TK173
  14. Experimental Study and Numerical Simulation on Aerodynamic Field of Tangential Bias Swirl Burner,TK223.23
  15. Characteristic Study of Combustion in Central Reverse Flame Chamber,TK223.21
  16. Numerical Simulation and Contrastive Analysis of Labyrinth Seals and Leaf Seals,TK263.2
  17. Numerical Study on Phosphorus Distribution in Water Environment of the Three Gorges Reservoir,X832
  18. The Design and Performance Simulation of External Valve Small Displacement Pump,TE933.3
  19. Analysis of the Impact of Tailings Dam Stability under Seepage Role,TV649
  20. Study on Hydraulic Fracturing of Low Permeability Reservoir,P618.13
  21. Numerical Simulation and Experimental Study of Air-Assisted Sprayer of Orchard,S491

CLC: > Aviation, aerospace > Aerospace ( Astronauts ) > Propulsion system ( engine, propeller ) > Engine control systems and devices > Engine test
© 2012 www.DissertationTopic.Net  Mobile